Installation
6. Connect WiringAccessories
The following accessories are available from your Bosch
WARNING:dealer or through Bosch Service: 800-944-2904. Please
Use only spring type wire nuts (included) to makereference the model number when requesting these items.
electrical connections. Replacement wire nuts must be
AccessoryModel #
rated for a minimum of (2) #18ga wires and a maximum
6? Duct Covers30?36?
of 4 #14ga wires, UL & CSA rated to 600V and 302o F/
BiscuitDCZ7607UCN/A
150o C. Request #189692 when ordering from
BlackDCZ7606UCDCZ9666UC
BSH.
Stainless SteelDCZ7605UCDCZ9665UC
For Internal Blower Use:WhiteDCZ7602UCDCZ9662UC
See Figure 1 or 2, page 3.12? Duct Covers30?36?
BiscuitDCZ7207UCN/A
1. Remove electrical knockout behind J box and
install 1/2? conduit connectors.BlackDCZ7206UCDCZ9266UC
Stainless SteelDCZ7205UCDCZ9265UC
2. Run 120V AC 60Hz, 15A supply wires through 1/2?
WhiteDCZ7202UCDCZ9262UC
conduit to hood electrical knockout behind J box
Recirculation Kit30?36?
cover.
BiscuitDRZ7007UCN/A
3. Connect blower cord wires to house wiring through
BlackDRZ7006UCDRZ9066UC
electrical knockouts. Use wire nuts supplied (white
Stainless SteelDRZ7005UCDRZ9065UC
to white, black to black, green to green).
WhiteDRZ7002UCDRZ9062UC
4. Connect blower cord at white connector behind
Charcoal FilterDHZ7960UC
connector access panel (if not already connected).
3 1/4 x 10TransitionDHZ3410UC
Verify that connectors are tightly connected.
Blowers*
For Remote Blower Use:
Integral Blower, 400 CFMDHG4001UC
See Figure 3, page 3.
Integral Blower, 600 CFMDHG6001UC
1. Remove 2 hood electrical knockouts and install
Remote Blower, 600 CFMDHG6003UC
1/2? conduit connectors.
Remote Blower, 1000 CFMDHG1003UC
2. Run black, white and green supply wires through*for use with DAH95 models only
1/2? conduit to hood electrical knockout behind
J box.
Figure 6 - Remote Blower Pigtail Assembly
3. Connect power supply wires to hood wires behind
J box (white to white, black to black, green to( PROVIDED W/HOOD )
N GND L1
green). Use wire nuts supplied.
4. Run 5 wires (#14 AWG) in 1/2? conduit from the
remote blower to the electrical knockout behind
the remote wire cover.
5. Connect remote blower wiring to ?pigtail? wiresBLACK
behind remote wire cover with wire nuts supplied
(white to white, black to black, green to green and
black to brown, white to white, red to red and
WHITE
blue to blue) See Figure 6.
BLUE
6. Connect other end of ?pigtail? at white connector.BROWN
BROWN
Verify that connectors are tightly connected.RED
WHITEWHITE
RED
M
7. Reassemble HoodBLUE
Reattach the following:GND
1. Connector access panel (internal blower only)
2. J box
3. Remote wire cover (remote blower use only)
4. Back filter rail
5. Filters
5 |