B100 TWOTWOTWO CHANNELCHANNEL POWER POWER AMPLIFIERAMPLIFIER
either absent or unacceptable.
BALANCEWhen the left/right signal balance is being shifted one of these LEDs will light to indicate
which channel is being attenuated. Balance can be adjusted in 1dB increments to up
to -6dB in either direction. Stepping past -6dB in either direction will mute that channel
fully and the LED for that channel will turn red.
REMOTE POWER CONTROL ~ 12 VOLT TRIGGER CONNECTOR:
Two trigger outputs are provided. A 12Vdc signal is T1placed and CCC pins across pins of the of the 12V the TRIGGERS
connector whenever the unit is fully powered up. Then the unit goes into standby this voltage is removed.
A 12Vdc signal will be
placed across the other
pair of 12V TRIGGER
output pins T2) ( when-
ever a certain user
programmed input is
selected as the source
input (see below for pro-
gramming instructions).
When any other input
source is selected the
12Vdc control voltage
will be removed from
these pins. Please note
that CCC means means common common here here and both and CCCboth pins pins are are electrically electrically connected connected and identical. and identical.
PROGRAMMING the T2 12v TRIGGER OUTPUT:
By default T2T2T2the triggered triggered output output is inactive. is Tinactive. o program this To output program to become this active output , to become active ,
whereupon a control voltage of 12Vdc will appear T2T2T2 & & CCC terminals terminals across whenever whenever a a
specific source is selected, use the handheld remote control as follows:
? select the source that you want to coincide T2T2T2 going going active.with active.
? While pointing the remote control at the B100, CODE button, press the followed by
the three digit code 247 using the keys numbered 1 through 0 in the illustration
at the left. On your remote control these keys, or buttons, AUX/PH (2), are labeled
ANALOG TUNER (4), DIGITAL CD (7).
? The three digit code should be entered within a few seconds CODECODECODE but-but-of pressing
ton or the unit will automatically return to normal operation.
? To clear T2T2T2the trigger trigger output, output, press the press CODE the button followed by the 3 digit code
248: AUX/PHAUX/PHAUX/PH (2), (2), ANALOG ANALOG ANALOG TUNERTUNERTUNER (4), (4), DIGITDIGITDIGITALALAL TUNERTUNERTUNER (8). (8).
HAND-HELD INFRA-RED REMOTE CONTROL:
The Bryston model B100 comes standard with a full function hand-held remote control unit.
The hand held remote unit is powered by two 3AAA´ batteries. To change the battery remove
the bottom cover plate by removing the four Philips screws on the rear of the remote unit.
Ensure that the batteries are correctly oriented and properly seated in the battery holder.
The B100 remote is a full function remote. It allows selection of all sources, volume up or
down (the volume control is a motor-driven design), mute ,left/right balance, power on/off
and discrete code entry.
We recommend maintaining a direct line-of-sight between the hand held remote unit and the
front of the B100 to ensure the most efficient operation of the remote features.
3 |
ACEC
