Playing Back Built-in Tunes
NOTE
Skipping Forward through a Tune
Y You can also use the dial to change the tempo setting while
the current setting is indicated by a value in brackets ([ ]) on
the display.
While playback is in progress, hold down the FF button.
Example: [T=120]1
Y The value indicates the number of beats per minutes.Y This skips forward through the tune measure-by-measure.
Y To return the tempo to its initial default setting, press theY The measure number and beat number appear on the
TEMPO and buttons at the same time.display while you are skipping forward.
Y At their initial default tempo setting, some Piano Group tunes
may change tempo part way through. After you change the
003 : 1
tempo setting for such a tune, playback will proceed at the
tempo you selected, from the beginning of the tune to the
Measure numberBeat number
end.
When you reach the point you want, release the FF
2
button to resume playback.
Pausing Playback
Looping a Musical Phrase
While a tune is playing, press the PAUSE button.
1
Y This pauses playback.You can select one or more measures and Oloop� them, which means
that they play again and again until you stop playback.
Press the PAUSE button again to restart playback from
2
While the tune is playing, press the REPEAT button while
the location where it was paused.1
the measure you want the phrase to start from is playing.
Y This causes the REPEAT indicator lamp to flash.
Skipping Back through a Tune
When playback reaches the measure you want to
2
specify as the end of the loop, press the REPEAT button
While playback is in progress, hold down the REWagain.
1
button.Y This starts repeat play of the loop.
Y This skips back through the tune measure-by-measure.Y To cancel repeat play of a loop, press the REPEAT button
Y The measure number and beat number appear on theagain so its indicator goes out.
display while you are skipping back.
006 : 1Changing the Melody Tone of a
Tune
Measure numberBeat number
You can select any one of the digital pianoOs 248 built-in tones as
the melody tone of a built-in tune. You can even change the melody
When you reach the point you want, release the REW
2tone setting while playback is in progress.
button to resume playback.
Press a TONE button.
NOTE1
Y Depending on what is being played when you press the REW
button, the skip back operation may not start right away whenUse the dial to select the tone you want.
2
you press it.
NOTE
Y You can return a tune to its preset default tone by selecting
the tune again.
E-18429A-E-020A
AP80R_e_17-28.p651804.8.26, 3:44 PM |