2. OPERATION CHART: MODULE QW-1395
TO SET TIMEn For watch with the elapsed time bezel
1)Pull the crown out when the second hand is atRotate the elapsed time bezel to align theSome water resistant models are equipped
12 oOclock position and the second hand stops. mark with the minute hand.with a screw lock crown. With such models,
After certain amount of time elapsed, read theyou must unscrew the crown in the direc-
2)Turn the hands clockwise and put the watch fourgraduation on the elapsed time bezel which thetion noted in the illustration to loosen it be-
or five minutes forward. Then back them out.minute hand points to.fore you can pull it out. Do not pull too forci-
3)In accordance with a time signal, push the crownThe elapsed time is indicated.bly on such crowns. Also note that such
in.watches are not water resistant while their
crowns are loosened. Be sure to screw the
crowns back in as far as they will go after
L(Light button)making any setting.
10
50
20
40
Crown30
Elapsed time bezel
ABOUT THE BACKLIGHT
Y Hold downL to illuminate the face of the watch.
Y The backlight of this watch employs an
electroluminescent (EL) light, which loses its il-
luminating power after very long term use.
Y Frequent use of the backlight shortens the bat-
tery life.
N 1 N |