Getting Ready
Initial Setup
After you first unpack your CASSIOPEIA, perform the following initial setup
procedure before using it for the first time.
1.Load the main battery (rechargeable battery pack) (page 25).
Important
Be sure to use the AC Adapter to charge the battery pack before doing anything else.
Your CASSIOPEIA will not operate correctly if you load the backup battery before
charging the battery pack.
2.Use the AC Adapter to charge the battery pack.
3.Load the backup battery.
4.Let the CASSIOPEIA rest for about five seconds, and then press the [Power] button.
5.The initial startup screen should appear first, followed shortly by a touch screen
calibration screen.
6.Follow the instructions that appear on the screen to set up your CASSIOPEIA.
? You can later change the settings you make with this procedure if you want. See the
separate Palm-size PC UserOs Guide for more information.
? The desktop appears after settings are complete.
? See OWhere to go for information...� on page 11 of this manual for information about
where you should go to find out about the versatile features and functions of your
CASSIOPEIA.
? Be sure to press the [Power] button to turn off power after you are finished using your
CASSIOPEIA.
Important
? If the touch panel does not respond when you tap it or if nothing appears on the
display, try performing a full reset (page 32). If this does not restore proper operation,
remove the main battery and the backup battery and wait for about five minutes.
Reload the main battery first and then the backup battery, and perform the above
procedure again from step 4.
? Make sure the positive and negative poles of batteries are facing correctly when you
load them into the unit.
? If the message OA problem with memory contents has been found...� appears on the
display, perform a full reset (page 32).
10 |
ACEC
