MA0403-EA
Operation Guide 1343/1794/2364
To Set Time and DateCrown
" The configuration of your watch(Normal position)
may differ somewhat from that
shown in the illustration.
[Setting date]First click
1) Pull the crown out to the first(Setting date)
click.
2) Set the date by turning the
crown.
Avoid setting the date
between the hour of 8:00 p.m.
and 1:00 a.m. (The date
display may not change in theSecond click
following day).(Setting time and day
3) Push the crown in to the
of the week)
normal position.
Day of
[Setting time and day of the week]
the week
1) Pull the crown out to theDate
second click when the second
hand is at 12 oOclock position24-Hour Hand
and the second hand stops.
2) Set the hands by turning the[Module 1343/2364]
crown. As you do, the day of
the week changesCrown
accordingly.(Normal position)
" After setting day of the week,
carefully set the time, making
sure to distinguish between AMFirst click
and PM.(Setting date)
3) In accordance with a time
signal, push the crown in.
24-Hour Hand
The 24-Hour Hand indicates the
current hour of the day, making one
complete rotation every 24 hours.Second click
(Setting time and day
of the week)
Day of
the week
Date
24-Hour Hand
[Module 1794]
For watch with the elapsed time bezel
Rotate the elapsed time bezel to align the 10
50mark with the minute hand.
After certain amount of time elapsed, read the4020
graduation on the elapsed time bezel which30
the minute hand points to.
The elapsed time is indicated.Elapsed time bezel
" Some water resistant models are equipped
with a screw lock crown.
" With such models, you must unscrew the
crown in the direction noted in the illustration
to loosen it before you can pull it out. Do not
pull too forcibly on such crowns.
" Also note that such watches are not water
resistant while their crowns are loosened.
Be sure to screw the crowns back in as far
as they will go after making any setting.
1 |
ACEC
