MA0507-EA
Operation Guide 4358
Hour hand Minute hand To set the time
1. Pull the crown out to the second
First clickclick when the second hand is
(Setting day and at 12 oOclock position and the
day of the week)
second hand stops.
2. Set the hands by rotating the
crown. Rotate the crown to
move the hands clockwise.
Second clickMove the minute hand four or
(Setting time) five minutes past the time you
want to set, and then back it up
Crownto the proper setting.
Second hand Day (Normal position)
" Carefully set the time, making
sure to distinguish between
Day of the week
AM and PM.
3. Push the crown back in to the
normal position to restart
timekeeping.
To set the day
1. Pull the crown out to the first click.
2. Set the day by rotating the crown away from you (in the
direction indicated by the arrow in the illustration).
3. Push the crown back in to the normal position.
Y Avoid changing the date setting while the current time is
between 9:00 p.m. and 1:00 a.m.
To set the day of the week
1. Pull the crown out to the first click.
2. Set the day of the week by rotating the crown towards you
(in the direction indicated by the arrow in the illustration).
3. Push the crown back in to the normal position.
Y Avoid changing the day of the week setting while the current
time is between 9:00 p.m. and 1:00 a.m.
Using the Stopwatch
Stopwatch second hand
Stopwatch minute hand
The stopwatch lets you measure elapsed time up to 59 minutes, 59 seconds.
To measure elapsed time
1. Press A to start the stopwatch.
2. Press A to stop the stopwatch.
" You can resume the measurement operation by pressing A again.
3. Check the elapsed time.
" The example below shows an elapsed time of two minutes, 44 seconds.
Stopwatch second handStopwatch minute hand
[44 seconds][2 minutes]
" Press B to reset the stopwatch.
This will enter the Timekeeping Mode.
Notes:
" Do not try to perform stopwatch operations while the crown is pulled out either to
the first or second click. If you try to press a button, you might accidentally cause
the crown to rotate and change the current time or day setting.
" If the starting positions of the stopwatch minute hand and second hand become
misaligned, use the following procedures to adjust the positions of the hands so
they point to 12 oOclock when the stopwatch is reset.
To adjust the positions of the stopwatch hands
1. Press B to reset the stopwatch, and check the alignment of the stopwatch minute
hand and second hand.
2. Pull out the crown to the second click.
3. Press A to move the stopwatch minute hand and second hand.
4. If the stopwatch minute hand is aligned correctly, proceed to step 5. To return the
minute hand to the 12 oOclock position, press B.
5. After making the adjustments you want, push the crown back in to its normal position.
" Note that pulling the crown out also stops the timekeeping second hand. After
performing the above procedure, you should also adjust the timekeeping setting.
For a watch with an elapsed time bezel
Rotate the elapsed time bezel to align the mark with the10
minute hand.50
After certain amount of time elapsed, read the graduation on4020
the elapsed time bezel which the minute hand points to.30
The elapsed time is indicated.
Elapsed time bezel
" Some water resistant models are equipped with a screw lock
crown.
" With such models, you must unscrew the crown in the
direction noted in the illustration to loosen it before you can
pull it out. Do not pull too forcibly on such crowns.
" Also note that such watches are not water resistant while
their crowns are loosened. Be sure to screw the crowns
back in as far as they will go after making any setting.
1 |
ACEC
