1,5 m. Max.
60 cm. Min.90 cm. Max.
IMPORTANT: The distance from the floor to the highest
part of the hose should be between 60 to 90 cm. (It is
advised to be between 60 and 70 cm). The hose must
not be bent nor twisted to avoid clogging. Should a
prolongation of the discharging hose be unavoidable this
must never surpass 1.5 m and must be of the same
diameter as the original hose.
Make sure the hoses are not too tense.
LevellingElectrical connections
Level the appliance by loosening or tightening the feet.Before plugging the appliance make sure that:
Once in the right position fix the feet by pushing the11. the mains of your installation is the same as on the
nuts against the base of the case. Accurate levelling
will prevent vibration, noise and displacement of therating plate of your appliance (the plate is sticked to the
appliance during operation.rear of the appliance).
21. The meter, the fuses, the wiring and the socket
Some vibration is inevitable, especially if placed on aoutlet can support the max. power absorbed stated on
wooden floor. Wooden floors are particularlythe rating plate.
susceptible to vibrations. For advice, consult a builder.31. The socket base and the plug must fit in adequately
If posible always place the appliance on a solid floor.without any reducing interposition, multiple outlets or
adapters. If necessary replace the socket outlet by an
adequate one.
The applicable rules for electrical security require
an adequate earthing. The plug of the appliance is
provided with such a device.
Make sure your socket outlet is provided with an
P0254adquate earthing too.
The manufacturer declines any liability in case of
accidents or incicents should these safety
measures not be observed.
16 |