not place carbonated or fizzy drinks in the freezer" Parts which heat up should not be exposed.Apoye las guÃas (Ha) sobre la parte interna superior
as it creates pressure on the container, whichWherever possible the back of the product shoulde inferior de la puerta del mueble como se indica en
may cause it to explode, resulting in damage tobe against a wall.la Fig.y marque la posición de los agujeros
the appliance.externos.Después de haber preparado los agujeros,
" If the appliance has been transported horizontally,
atornille las guÃas con tornillos sobre la puerta del
it is possible that the oil contained in the
Installationmueble.
compressor Ãlows in the refrigerant circuit.It is
" During normal operation, the condenser andadvisable to wait at least two hours before
compressor at the back of the appliance heat upconnecting the appliance to allow tl?e oil to flow
considerably.For safety reasons, minimumback in the compressor.
ventilation must be as shown in the relevant
Figure.
Environment Protection
Attention: keep ventilation openings clear of
Aplicar a presión la tapa (Hc) sobre la guÃa (Ha).
obstruction.This appliance does not contain gasses which
could damage the ozone layer, in either its
" If the appliance is transported horizontally, it is
refrigerant circuit or insulation materials.The
possible that the oil contained in the compressor
appliance shall not be discarded together with
flows in the refrigerant circuit.It is advisable to
the urban refuse and rubbish. Avoid damaging
wait at least two hours before connecting the
the cooling unit, especially at the rear near the
appliance to allow the oil to flow back in the
heat exchanger. Information on your local
compressor.
disposal sites may be obtained from municipal
" There are working parts in this product which
authorities.The materials used on this appliance
heat up.Always ensure that there is adequate
marked by the symbol are recyclable.
ventilation as a failure to do this will result in
component failure and possible food loss.See
installation instructions.Abra la puerta del aparato y la del mueble de aproxi-
madamente 90°.Coloque les escuadras sobre las
guÃas.Mantenga juntas la puerta del aparato y la dei
CONTENTS
mueble y marque los agujeros como mostrado en la
figura.
Warnings 13Hints for refrigeration16
Hints for freezing16
Use 14
Hints for storage of frozen food16
Maintenance17Cleaning the interior 14
Operation14
Periodic cleaning17
Temperature regulation15
Periods of no operation17
Fresh food refrigeration15
Interior light17
Freezing fresh food15
Defrosting17
Storage of frozen food15Quitar las escuadras y marcar a 8 mm del borde
Customer service and spare parts18
Thawing15externo de la puerta con el clavo (K).
Ice-cube production15Technical information18
Shelf holders15
Installation18
Movable shelves15
Positioning the door shelves16Location18
Freezing Calender16Electrical connection18
Hints16Door reversibility19
Instructions for built-in19
USE
Cleaning the interior
Before using the appliance for the first time, wash
the interior and all internal accessories with luke-
Operation
warm water and some neutral soap so as to remove
the typical smell of a brand-new product, then dry
Insert the plug into the wall socket.
thoroughly.
Open the refrigerator door and turn the thermostat
knob, clockwise, beyond the ?O? (STOP) position.
Do not use detergents or abrasive
The appliance will start to operate.
powders, as these will damage the finish.
1411 |
ACEC
