INSTALLATIONOPERATION
Position the tumble dryer so that the plug remains accessibleconverted to rear venting before a permanent connection can beOpen the door.
NEVER SWITCH THE DRYER OFF AND LEAVE A
after installation. Do not block the vent at the front of the dryer,
made.HOT LOAD IN THE DRUM.
as this will impair the working of the machine. The applianceLoad clothes loosely into the drum.
The dryer can be used with or without a vent hose but,
must not be installed behind a lockable door, a sliding door or aWhen drying large items such as sheets, we suggest you
When using a vent hose, remember the following points:
door with hinges on the opposite side to that of the tumble dryer.Load sheets first, starting with one corner.periodically stop the dryer to redistribute the load.
� The vent hose must be at least 10cm (4 ins) in diameter.
TUMBLE DRYER VENTING
� No more than three right-angled bends should be allowed whenClose the door.To stop the machine during the middle of the programme simply
Your tumble dryer will release warm, damp air in one of these
open the door; the drum will stop rotating automatically and
three ways:positioning the vent hose.
Dry your hands.restart when you close the door. If the tumble dryer has a start
� Do not distort or constrict the vent hose as this will reduce the airflow.
button then it will be necessary to press this to restart the machine.
� The vent hose must not be shared with other appliances, for Check that the timer is in the �0O position.
example, a cooker hood outlet.To lengthen or shorten a timed programme, reset the timer knob.
� When drying, the vent hose must always be extended to an open Plug in the machine.
door or window.
Select correct heat position (see programme chart on control
AFTER REMOVING THE DRIED CLOTHES:
FINAL INSTALLATIONpanel for recommendations).
(1) Front Venting. Venting
(2) Fixed Rear Venting. VentingPlace the filter in its operatingALWAYS CLEAN THE FILTER. Failure to clean the filter will
through a grille on the plinth.
through a hole at the bottom ofposition as shown in the diagram.Set the timer to the required time setting (see programme chartextend drying times and could cause the safety cut-out to
A kit is available to convert tothe back panel. A vent hose is
rear venting.If you wish to change the side onon control panel for recommendations). then press start button.operate. There are two types of filter your dryer main contain.available to convert to
extendible rear venting.which your door opens, see the
instructions on the back page.The drum will begin rotating. Reversing drum models will stop�Pull the filter upwards and away
every few minutes to rotate in the reverse direction for a shortfrom the appliance.
Remove any dust by wiping the drum
(3) Extendible Rear Venting.time.
and door with a damp cloth. Any initial
This contains a retractable vent
smell from the heater should�Remove any threads or fluff by
hose.Should the clothes become dry before the cycle has finished, or ifhand or with a soft brush.
disappear after the first period of
heating.an excessive programme time has been selected, the drum will
continue to rotate while the thermostat will automatically switch�Slide the filter back
FITTING OF FILTERthe heater off to prevent over-drying and save energy.
The best solution is to make a permanent connection through�Wash the filter occasionally in
Grip middle piece of filter with fingers.
either a wall or a window. This is particularly recommended forThere is an automatic 12 minute cool down period at the end ofdetergent solution and with a
small, cool rooms and a kit for this purpose is available as anSlide the filter into the space below
every cycle, during which the heater is switched off. This helps tosoft brush to remove small
accessory. However, venting arrangement (1) requires that it bethe door in a right angle position.
minimise creasing.particles.
THE CONTROLSPREPARATIONADDITIONAL INFORMATION
A. THE TIMERCheck care labels inside the garments.ANY PROBLEMSOPTIONAL EXTRAS
Select the requiredCARE LABELS YOU MAY FIND ON YOUR
If the clothes are not dry after normal drying time:
Front to Extendible Rear Venting Kit
drying time based
FABRICS
on the� Check that you used the correct heater setting.To convert your dryer from front venting to extendible rear venting.
B
recommendations
Suitable for tumble drying� Check that you have not set the timer within a coolVent Hose
A
on the control
down period.Only available for fixed rear dryers. Leads the warm, damp air to
panel.
Tumble dry using full heatan open door or window.
� Check that the lint filter has been cleaned. A blocked
Wall/Window Vent Kit
B. HEAT ESTumble dry using half heatfilter will restrict the airflow.
To make a permanent connection through a wall or window. Front
Select the required� Check that your dryer is heating - below the door to theventing dryers need converting to rear venting before installing this
Do not tumble dry
heat setting basedright side, should feel warm to the touch after the firstkit (see �Front to Extendible Rear Venting KitO above).
on theB10-15 minutes of its programme. Failure to heat may
Stacking Kit
recommendationsAindicate the safety cut-out has operated. To reset,Do not tumble dry woollen or wool mixture articles unless the
on the controlsimply press the red button at the rear of the machine.To enable your dryer to be secured onto the top of a front loadingarticle is labelled to be suitable due to a possibility of shrinkage.
panel.If it has operated, a sharp Oclick� will be heard. This cut-to save floor space
Roll dripping wet articles in a towel to remove excess water. out only operates if the airflow is severely restricted so
The above items can be purchased as accessories for your tumble
Place delicate articles e.g. tights, scarves, inside a pillowcase. make sure the filter is clean, the air inlets and outlets atdryer from your supplier.
Athe front and back are not blocked, and that all other
B
To avoid the need to iron easycare polyester/cotton items it isrestrictions are removed before re-starting.
TECHNICAL DATA
i.e half fill drum
If the cut-out continues to operate after checking the
It is better to dry small and large articles together.OVERALL DIMENSIONS:
above points, you should contact your service agent.
Height: 85 cm Width: 59.5 cm Depth: 53 cm
We suggest a fabric conditioner to be used to reduce static
electricity.
A BMAXIMUM DRY WEIGHT LOADS:
If your machine does not work check the following before
Do not overload the dryer or dry large bulky items such asCotton 6kg
calling a service engineer:
duvets or sleeping bags as it is important that the airflow throughfor minimum creasing 2kg
C. START BUTTON
the dryer is not obstructed.Delicates 2kg
� Check that there is a supply of electricity.
Press start button
Do not place items contaminated with inflammable substancesFor electrical ratings see plate on back of dryer.
after selecting� Check that the door has been properly closed and the
in the dryer, such as petrol, cleaning solvents, cooking oil, fat, orFor Model No. see serial plate inside door needed when requesting service
the required dryingmachine is switched on.
hair lacquer. These can cause fires. For the same reason, do notRoom temperature range 5uC to 30uC.
time� Check the plug internal connections.
dry rubber, foam rubber, plastic or paper.Your washing machine should have a spin speed of not less than 800rpm. |