11060 A3 89231 GB Brdsht 19/11/03 2:55 PM Page 2
IMPORTANT USER INFORMATIONTHE CONDENSER
These notes are provided in the interest of safety.
You must read them before installing or using the appliance.The condenser and ducting should be cleaned 3 or 4 times a yCLEANING THE earCONDENSER
or more frequently if the dryer is in constant use. See OCLEANING
� This tumble dryer is intended fNORMAL DOMESTICor � It is important to clean fluff from the window of the dryTHE CONDENSER�eropposite.CAUTION: For maximum efficiency, the plates are made from
USE ONLY.and around the door seal after each drying cycle. Failurevery thin aluminium and are easily damaged. Do not try to poke
NOTE: The condenser will discolour through use.
�Any electrical work required to install the applianceto do so could result in water leaking.anything between the plates or use a hard object or tool for
cleaning. At all times, handle the condenser carefully and avoid
should be carried out by a qualified person.� DO NOT use a two-way adaptor, or extension lead. The
crushing the plates.
dryer must be connected to its own socket.
� Please note it is note it is not recommended that the dryer
REMOVING THE CONDENSER
�Remove the condenser (see opposite).
be placed directly next to ovens or cookers, as the� DO NOT block the air inlets at the front and back of your
performance of the dryer may be affected.dryer.�Firmly pull the condenser out.�Flush the fluff from between the plates under running water
� Do not stack the tumble dryer on top of other appliances� DO NOT allow fluff to accumulate around the tumbleand carefully shake off excess water.
without the correct stacking kitdryer.
�It is important to clean the lint filter after each dr� DO NOying cycleT exceed the recommended maximum load.
RE-INSTALLING THE CONDENSER
and the condenser every three or four months or the
� DO NOT allow children to tamper with the controls and
restrictions to airflow will extend drying times and could�Carefully push the condenser back into the machine, until it is
keep them away from the dryer when it is in operation.
cause the safety cut-out to trip.pushed fully home and a Oclick� is heard.
� DO NOT place articles in the dryer if anything other than
�Ensure all lint and fluff is removed from around the grille seal
� Under no circumstances should anything other than the
a water solution has been used in the cleaning process.
before closing or water may leak.
recommended articles be placed in the tumble dryer.
� DO NOT attempt to dry dripping wet articles or items�IMPORTANT:The dryer may leak if the condenser is not
� The tumble dryer should be serviced by an appointedcontaining foam rubber or rubber-like materials.correctly re-installed.
service organisation and only genuine parts used.
� DO NOT use the tumble dryer if you suspect that it is
� It is dangerous to alter or modify the product in any way
damaged in any way. Under no circumstances should you
other than fitting authorised accessories.attempt to repair the appliance yourself. Repairs carried�Whilst the condenser is
removed, clean as much fluff
�W e recommend that the appliance is unplugged eachout by inexperienced persons may cause serious injury.
as possible from inside the
time after use. It should always be disconnected from theConsult your local appointed service engineer and insist
ducting by reaching a hand
electricity supply if it is to be left unattended fon genor longuine spare parts.
into the machine. In particular,
periods (i.e. weekends, holidays etc.)
keep the passage from the fan
� The rear of the dryer gets quite hot during use. Position
THIS APPLIANCE MUST BE EARTHEDclear (on the right hand side of
the dryer so that the back is not accessible while in
the condenser duct).
operation.
This label, positioned on the rear of your
�After cleaning, re-install the condenser (see opposite).
dryer, indicates the surface is hot when in
operation - avoid touching
CAUTION
HOT SURFACE
4213 094 89231
Replace the child safe peg in the top of the, now reversed, door.
CE FOR FUTURE REFERENCE.THEM IN A SAFE PLAKEEP Reverse the door and re apply the hinge screws.
GB
THIS APPLIANCE.Y BEFORE USING OUGHLTHORUCTIONS THESE INSTRPLEASE READ opening.
the door Remove the four screws from the opposite side of the door opening. Place these screws in the hinge holes on the other side of
:ANTTIMPOR
removing the 4 screws. Do not use a power screwdriver as this may damage the screw threads.
Now unscrew the door hinges from the machine byanticlockwise. First remove the child safety peg from the top of the door by rotating 90u
Large Door Opening :-
Remove door from hinge blocks.
hinge blocks and secure with screws (E)and refit to opposite side as shown.
plate (D). Remove hinge block screw (E).
(B) as shown. Refit buffer (J). Fit door to Remove hinge screws (F) and hinge (G)
remove buffer. Remove screws (C) and latch
screw (H) at top of door and re fit switch strike
GFstrike (B) and replace screw. Undo screw (J) and Refit latch plate (D) with screws (C). Remove
Open the door. Undo screw (A) remove switch
JECDE
DC
J
32
1
BHDryers fitted without hinge cover :-AB
hinge cover screw (E). Close the door.
Refit buffer (J).plate (D) with screws (C)screws (C) and latch plate (D). Remove
and refit switch strike (B) as shown.and hinge cover (F). Open the door.screws (G). Remove door. Fit latch screw (J) and remove buffer. Remove
Remove screw (H) at top of door closed position. Refit screws (G) remove it. Remove two outer switch strike (B) and replace screw. Undo
Fit screw (E) to secure hinge cover. Reverse door and fit to dryer in Pull the hinge cover (F) forwards to Open the door. Undo screw (A) remove
JJ
B
Dryers fitted with hinge cover :-
Your dryer is fitted with a reversible door. To change the direction of opening proceed as follows for your type of door.
INSTRUCTIONS FOR USEREVERSING THE DOOR OPENING |