The Slimline Turbo is a decorative gas fire which incorporates a horizontal flue that inhas been designed specifically to be used
applications that do not have a conventional chimney or flue but can be located so thll.at the flue can terminate on an outside wa
The fire is switched `ON? and `OFF? from a push button situated on the right hand top cornby a er of the surround and is controlled
fully modulating thermoselector thermostat. Once the desired room temperature that hasach beened, selected by the control has been re
the gas input to the appliance is automatically reduced to low. The fire has been co apnpslicatiotructedn tos enable it to be installed into
where the warmth and comfort of an open fire and high radiant heat is required. This seapplians, thece is intended for decorative purpo
coal bed uses ceramic simulated coals to give a realistic appearance and to allow secon ensduaryre air to be entrained into the bed to
clean combustion. An aerated single port steel burner is used running parallel across tn Dehvie frce ont of the fire. A Flame Supervisio
(FSD) is fitted to ensure that should the pilot flame be extinguished for any reaes gaon,s sup (incpludly toing turning off the appliance), th
the burner is cut off until a full lighting sequence is repeated. A battery operatedilo spt senarks gorenerator is used to ignite an Oxy/p
(O.D.S) which will cause the appliance to 'shut off' in the event of continued spillaguee occurring under hazardous or blocked fl
conditions. The fire bed consists of ceramic fibre components and coals all of that arquie rred. Itemovable for cleaning purposes when re
is important when relaying the coal bed and coals to follow the instructions correctly.
TECHNICAL DATA
TYPE OF GASG20 only
SETTING PRESSURE20 mbar +/- 1 mbar (cold)
GAS INPUTS (Gross)Max 6.6 kW (22500 Btu/h)
Min 2.83 kW (9700 Btu/h)
Pilot 0.26 kW (890 Btu/h)
IMPORTANT NOTES
This appliance is intended for decorative purposes, it is designed and manufactured t S.Io th.e relT. 8 evant requirements of EN 509, BSI
and BS 5258 Pt 16 : 1991, it is for use on Natural Gas Only.
Areas of this appliance will become hot after prolonged running and it is recommended, elderly that for the protection of the very young
and infirm a fireguard conforming to BS 6539 or BS 6778 be used. Combustible material nos shrould not be put or left on the hearth
should the coal bed be used to burn rubbish or other materials.
The type of front and fret recommended is shown as Fig 1 in this instruction, it h inas a pto there coforatedal fret to allow air to be drawn
bed for combustion and over the controls for cooling purposes. If other fronts and ufmr openets are to be used they must have a minim
area in the fret of 50 sq. cms and 60 sq. cms in the front.
Additional purpose built ventilation is not required for this appliance in GB onlyt, fh ao mir Inriemalanl d (IE) ventilation is required wi
cross sectional area of 100 sq. cms and should be checked regularly to ensure that ied int is free from obstruction. It must be fitt
accordance with the rules in force.
Care must be taken on the selection of wall coverings within close proximity of the fiayre be as some vinyl and embossed materials m
become discoloured by convected heat. Soft furnishings must be kept clear from the radianthet heat of the fire and from impinging
hearth area. The hearth must not be covered by any combustible materials such as carpets etc.
This appliance is fitted with an Oxy-pilot, which in the event of the flue being bloacukseeds the or hazardous conditions exists which c
appliance to spill products of combustion, will shut `OFF' the gas supply. If whthen the ape fplianirec is reelit the sequence is repeated
must be turned 'OFF' and not used until expert advice has been obtained.
In very strong wind conditions the fan may be heard to increase in speed, this is nanoce, ast detr thimenetal to the operation of the appli
increase is to extract those products that may be prevented leaving the flue by the w anindd. Exceptionally the fire may shut down
require relighting due to a sustained strong gust.
The curing effect of heating the coals will cause anugh no initial odout harmful,r w mhaichy r,e althquireo additional ventilation until the
odour has disappeared.
This product uses fuel effect pieces, gaskets and insulation material containing Refractory Ceramic Fibre (RCF), which are man-
made vitreous silicate fExcessivibresexe pos. ure to these materials may cause temporary irritation to eyes, skin and respiratory tract,
consequently, it makes sense to take care when handling these articles to ensure that the release of dust is kept to a minimum.
This fire will run for 4.4 hours on one therm of gas with the gas control on the high setting.
-2- |