TO LIGHT THE APPLIANCE
1. Remove the fret (controls cover).
2. Press and turn the gas control until the indicator mark is opposite to IGN. Keep the control fully depressed.
Press and release the ignition button. Check that the pilot flame has lit at all ports. Keep the gas control
depressed for a further 20 seconds. Release the gas control and check the pilot remains alight.
3. Depress the gas control slightly and turn fully anticlockwise until the indicator mark is opposite the small flame
symbol. The burner will now ignite from the pilot assembly and run at the low rate.
4. Depress the gas control slightly and turn clockwise until the indicator mark is opposite to the large flame
symbol. The burner will now run at its maximum rate.
5. To turn the applia?off?, rence turn the control to the?off? position.
6. If for any reason the fire cuts out, return the control knob to the `? position and wait 3 minut before re-es off
lighting.
REMOVAL OF DEBRIS or SOOT DEPOSIT
Allow the appliance to cool for two to three hours before removing all of the coals and ceramic blocks for cleaning
purposes. Once all the ceramics are removed from the fire bed check that no debris is located in the burner slots
(both front & rear). If any debris is present it may easily be removed by using a small piece of thin cardboard to
ease out any foreign matter. Be sure to remove the cardboard after use. Cleaning should be carried out in a well-
ventilated area or in the open air, by gently brushing with the pieces held away from your face so that you avoid
inhaling the dust. We do not recommend the use of a normal domestic vacuum cleaner, which may blow dust back
into the air.
SETTING UP THE COAL BED. (See the identification sheet on page 8)
Components
2 burner inserts.16 Large Coals.
Coal support shelves (L&R hand).4 Medium Coals.
Artificial coal front. 2 Triangular Coals
Place the left and right coal support shelves with the rebate on the underside, over the rear flange of the support
channel. Place the two Tee shaped burner inserts into the channel between the front and rear ports of burner. Locate
the fibre artificial coal front on the shelf above the fascia panel. Figures 4 & 5.
COAL LAYOUT
First Layer. Position 3 large coals with their rear edge on the burner inserts. Place 4 coals at the rear of the coal
support shelf and lay 5 more across as a middle row. See fig. 6. Two triangular coals are placed one either side of
the front row ensuring that the one on the right does not lay on the pilot assembly.
Second Layer. Position the remaining 4 large with the 4 medium coals in the positions shown in fig.7.
To obtain the best visual appearance it may be necessary to make slight adjustments to the position of the coals.
NOTE: Additional coals must notI bef any use of the coals or the coal bed becomes damagd. ed, lost or broken,
replacements must be obtained before the appliance is used.
VENTILATION
Purpose built ventilation is not required for this appliance in GB only. For Ireland (IE) ventilation is required with a
minimal cross sectional area of 100 sq. cms and should be checked regularly to ensure that it is free from
obstruction. It must be fitted in accordance with the rules in force.
CLEARANCE TO SHELVES
Minimum clearances to underside of a 150mm (6ins) combustible shelf from the top of the fire opening must be
228mm (9ins). Add 12.5mm (1/2in) to this clearance for every 25mm (1in) increased depth of shelf.
CLEARANCE TO SIDES
Minimum Clearance required to any combustible material to the side of the appliance must be 150mm (6in) |
ACEC
