Initial SetupInitial Setup
PREFERENCE / Audio Settings
Follow the same procedure as Video Settings to select Audio Settings.Virtual Surround
You can enjoy a simulated 3D effect from two speakers by setting
PreferenceAudio
Virtual Surround to On.Video
AudioFollow the same procedure as �Digital Output� to set the VirtualDigital OutputOff
Parental ControlsSurround option.Dynamic RangeOff
Auto PlayVirtual SurroundOff
Select Virtual
Auto ClockVCR ReceptionStereo
Surround
VCRTape Play BackHi-Fi
InstructionsOff
Enter-Confirm Setup-ExitInstructionsOn
Move &
Digital OutputEnter-Confirm Setup-Exit Move&
VCR Reception
1Use [&/ ] to select �Digital Output� while the Audio
Audio
submenu is displayed.Select your desired audio source for VCR recording (Stereo,
Audio
Digital OutputOffMono, or SAP).SETUP
2Press [ENTER] or [] to go to the second level.Select Digital
Dynamic RangeOffOutputFollow the same procedure as �Digital Output� to set the VCR
Digital OutputOff
3Use [&/ ] to select the desired digital output type.Virtual SurroundOffOffReception option.Dynamic RangeOff
VCR ReceptionStereoVirtual SurroundOffSelect VCR
4Press [ENTER] to confirm your selection.Tape Play BackHi-FiBitstreamVCR ReceptionStereoReception
LPCMTape Play BackHi-FiStereo
5Press [SETUP] to exit the menu.Instructions
Enter-Confirm Setup-Exit Move& InstructionsMono
OffEnter-Confirm Setup-Exit Move& SAP
No signal will be output from the Digital Audio Out jacks.
LPCMTape Play Back
Select when connected to a 2 channel digital stereo amplifier. The DVD Recorder+VCR's digital audio signal willSelect your desired audio signal for VHS tape playback (Hi-Fi,Audio
be output in the PCM 2ch format when you play a DVD (or VHS tape) recorded with a Dolby Digital (only for
Linear, or Mix).
DVD) or MPEG soundtrack. If the DVD is recorded with a DTS sound track then no sound will be heard.
Follow the same procedure as �Digital Output� to change the TapeDigital OutputOff
Dynamic RangeOff
BitstreamPlay Back option.
Virtual SurroundOffSelect Tape
Select when connected to a Dolby Digital or DTS decoder (or an amplifier or other equipment with a DolbyVCR ReceptionStereoPlayback
Digital or DTS decoder).Tape Play BackHi-FiHi-Fi
Linear
Instructions
Enter-Confirm Setup-Exit Move& Mix
Dynamic Range
While watching DVD movies, you may wish to compress the
Audio
dynamic range of the audio output (the difference between the
loudest and quietest passages). This allows you to listen to a
Digital OutputOff
movie at a lower volume without losing clarity of sound. SetDynamic RangeOff
Select Dynamic
�Dynamic Range� to Low or High for this effect.Virtual SurroundOff
Range
VCR ReceptionStereo
Follow the same procedure as �Digital Output� to set the Dynamic
Tape Play BackHi-FiOff
Range.
Low
Instructions
High
Enter-Confirm Setup-Exit Move&
2829 |
ACEC
