PROPER TOILET CLEANING AND MAINTENANCE
Dometic china toilets should be cleaned regularly for maximum sanitation and
operational efficiency. You can clean it just as you would a household toilet.Fig. A
Do not use caustic chemicals, such as drain-opening types, as they will
damage the seals.
?
BOWL CLEANING: For stubborn stains, use SeaLand Bowl and Seal Cleaner
(Fig. A). It?s manufactured especially for use with Dometic toilets. In certain
locations where water is hard, a build-up of lime may dull the toilet bowl finish.
Restore the shine with this SeaLand cleaner. If you cannot find it in your area,
contact Dometic for your nearest dealer. If this cleaner is not available, you can
?
also use Bar Keepers Friend cleanser. It is not necessary to vigorously scrub
with either product. Please follow label instructions.
SEAL CLEANING: After an extended time, mineral deposits from hard water can
build up under the edge of the rubber bowl seal, resulting in a slow leakdown of
water from the bowl. To prevent this mineral build-up, periodically clean under the
bowl seal with SeaLand Bowl and Seal Cleaner (Fig. B).
1. Shut off water supply and power to vacuum pump or vacuum generator.
2. Apply cleanser onto a cleaning brush, open the flush ball by pressing on flush
lever, and scrub under the seal. Make sure to push brush bristles between
Fig. B
bottom of seal and top of flush ball surface to scrub all parts of seal that come
into contact with flush ball.
3. Close ball and wait 2-3 minutes.
4. Open flush ball. Use brush and water to rinse away cleanser and loosened deposits.
5. After cleaning, turn on water and electrical power to toilet system.
WINTERIZING - TOILET
At the end of each season, the Dometic toilet should be winterized for storage by either draining or using potable
water-safe antifreeze in the system.
To drain:
1. Thoroughly flush system with fresh water.
2. Empty holding tank.
3. Model 1606 only: Shut off water supply to toilet(s), and remove inlet waterline (Fig. C). Do not remove brass
cap on bottom of valve.
Model 1609, 1648: Shut off water supply to toilet(s), and remove plastic cap from bottom of brass fitting (Fig. D).
Do not remove brass fitting on bottom of water valve.
4. Press flush lever until all water is drained from toilet(s).
Fig. CFig. D
7 |
ACEC
