Programming Tutorial
Advanced Sequencing
Advanced This section shows you how to set up Audity 2000 for sequencing.
Sequencing
Pre-Sequence SetupSuppose that you want to have your sequencer set up everything for you
before the start of the song. Good idea. This makes the Audity 2000 setup
procedure automatic and prevents the wrong presets from playing.
The basic idea of a pre-sequence setup is to send out MIDI SysEx infor-
mation just before the start of the song. This MIDI information selects all
the proper presets and adjusts the mix and pan positions of each preset.
Note: Audity 2000 setup information should be transmitted from the
sequencer before the song actually starts, perhaps during a lead-in measure
or countdown. DO NOT send setup information just before the Ţrst beat of
the song or MIDI timing errors could result.
Initial Setup
Audity 2000 includes a feature that was developed especially for pre-
sequence setup. By storing the Multimode Map settings in the beginning of
your sequence, you can be sure that all the correct presets and MIDI
settings are retained during playback. It is a good idea to send the Master
settings as well since the MIDI mode is information is contained there.
1.Set up the Audity 2000 for sequence play back. Take care that the
presets are on the appropriate channels, the MIDI mode is set to
OMulti,� and the Change Ţeld is set to Oignored.�
2.Prepare your sequencer to receive MIDI SysEx data. This procedure
varies with the type of sequencer you are using. See the instructions
that came with your sequencer for detailed instructions.
3.Set your sequencer to the Orecord� mode.
4.Begin transmitting the Multimode Map from the Audity 2000.
5.Cut and paste the SysEx data into the lead-in measure of your sequence,
leaving at least a 300 mSec gap between the Multimode Map and the
Master settings. Allow more time after the last SysEx data burst to allow
Audity 2000 enough time to Odigest� the data.
6.Send MIDI volume information (controller #7) for each MIDI channel
used on Audity 2000.
7.Send MIDI pan information (controller #10) for each MIDI channel
used on Audity 2000.
yyyyNote: If the wrong Now your song will play perfectly every time using the proper presets,
presets are being selected, check volumes and pan positions. In addition, presets, volumes and pan positions
the MIDI Program -> Preset (or anything else for that matter) can be adjusted in real-time during the
map.song.
Audity 2000 Operations Manual 143 |
ACEC
