Electrical Requirements
Any electrical work required to install thisWhen wiring the plug, ensure that all strands of wire are
appliance should be carried out by a qualifiedsecurely retained in each terminal. Do not forget to
electrician or competent person.tighten the mains lead clamp on the plug. If your
electricity supply point has only two pin socket outlets,
Before switching on, make sure the electricity
or if you are in doubt, consult a qualified electrician.supply voltage is the same as that indicated on the
appliance rating plate(the rating plate is fixed to
Should the mains lead ever require replacement, it is
the rear of the appliance).
essential that this operation be carried out by a qualified
The flexible mains lead is supplied connected to a B.S.
electrician and should only be replaced with a flexible
1363 fused plug having a fuse of 13 amp capacity.
2
cord of the same size i.e. 1,5 mm.
Should this plug not fit the socket outlets in your home,
it should be cut off and replaced with a suitable plug,
After replacement of a fuse in the plug, the fuse cover
following the procedure outlined below-
must be reffited. If the fuse cover is lost, the plug must
not be used until a replacement cover is obtained. The
WARNING
colour of the correct replacement fuse cover is that of
Such a plug cannot be used for any other
the coloured insert in the base of the plug or the colour
appliance and should therefore be properly
that is embossed in words in the base of the fuse recess
disposed of and not left where children might find
or elsewhere on the plug. Always state this colour when
it and plug it into a supply socket - with the
ordering a replacement fuse cover.
obvious consequent danger.
Only 13 amp replacement fuses which are ASTA
approved to B.S. 1362 should be fitted.
N.B. We recommend the use of good quality plugs and
wall sockets that can be switched off when the machine
is not in use.Note:Socket outlets are not permitted in bathrooms,
neither should any provision be made for connecting
moveable electrical appliances. No stationary appliance
IMPORTANT: The wires in the mains lead fitted to
is to be installed within reach of a person using bath or
this appliance are coloured in accordance with the
shower.
following code:
GREEN AND YELLOW- EARTH
In the case of permanent connection it is necessary that
BLUE- NEUTRALyou install a double pole switch between the appliance
and the electricity supply (mains), with a minimum gap
BROWN- LIVE
of 3 mm between the switch contacts and of a type
suitable for the required load in compliance with the
As the colours of the wires in the mains lead of thiscurrent electrical regulations.
appliance may not correspond with the coloured
The switch must not break the yellow and green earth
markings identifying the terminals in your plug, proceed
cable at any point.
as follows:
The wire which is coloured green and yellow must be
connected to the terminals in the plug which is marked
with the letter E or by the earth symbol or coloured
green or green and yellow.
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or
coloured black.aa aa a
a
The wire which is coloured brown must be connected to
the terminal which is marked with the letter L or
coloured red.
WARNING - THIS APPLIANCE MUST BE
EARTHED.
5 |
ACEC
