Fig. 8
Position the
runners (H) at the
H
top and bottom of
the inside of the
kitchen unit as
shown in Fig. 8
20mmand mark the
position of the
external holes.
After preparing
D094
the holes, screw
the runners to the kitchen unit door using
3.5x16 mm screws.
Fig. 9
Open both the
8mm
appliance door
and that of the
kitchen unit to
approx. 90°.
Place the little
plates over the
runners. Hold the
doors of the
appliance and the
PR34
unit together and
mark the holes.
Fig. 10
Remove the little
plates and make
the holes with a
diam. of 2 mm.
Replace the little
plates over the
runners and
screw in the
screws provided
(3.5x16 mm).
PR35
For the alignment
of the kitchen unit door, if necessary, use the
clearance size of the slotted holes.
At the end of the procedure, check that the doors of
the appliance and the kitchen unit open properly.
33 |
ACEC
