Setting electronicallyFilling with salt
The dishwasher is factory set at level 5. If itOs necessary to set
a new level, proceed as follows.Special salt can be added in one of two ways:
If you are using dishwasher detergent that already contains
1.With the dishwasher switched off, press the On/Off push salt, the detergent including the salt is placed in the
button, all indicator lights of the programme push buttons
detergent compartment.
will illuminate (setting mode).- In this case the water softener must manually be set to 1
and electronically to 1 to ensure that the special salt is
2.Press simultaneously function push buttons 2 and 3, the
taken from the detergent container only.
indicator lights of the function push buttons 1, 2 and 3 start
flashing.If you are using dishwasher detergent and salt separately,
the special salt is to be put into the salt container.
- In this case the water softener must manually be set to 1
or 2 and electronically between 1 and 10 (depending on
the water hardness in your area) to ensure that the
special salt is taken from the salt container only.
SO577
3.Press the function push button 1, the indicator lights of Only use salt specifically designed for use in
function push buttons 2 and 3 turn off while the indicator dishwashers.
light of the push button 1 goes on flashing, at the same time All other types of salt not specifically designed for use in
the "end of programme"indicator light illuminates, along a dishwasher, especially table salt, will damage the water
with a sequence of audible signals.softener.
Only fill with salt just before starting one of the washing
programmes (not the Rinse and Hold programme).
This will prevent any grains of salt or salty water, which
may have been spilt, remaining on the bottom of the
machine for any period of time, which may cause
corrosion.
SO578
The current level is indicated by the number of flashes and To fill:
audible signals.
1.Open the door, remove the lower basket and unscrew the
Example: 5 flashes + 5 audible signals = level 5
cap of the salt container by turning it anticlockwise.
4.To change the level, press push button 1. Each time the
2.Pour 1 litre of water inside the container (this is necessary
push button is pressed the level changes.
only before filling with salt for the first time).
Examples:
3.Using the funnel provided,
if the current level is 5, by pressing push button 1 once,
pour in the salt until the SALE
level 6 is selected.
container is full.ZOUT
if the current level is 10, by pressing push button 1 once, SALT
SALZ
level 1 is selected.4.Replace the cap making SEL
sure that there is no trace
5.To memorise the operation, switch off the dishwasher by
of salt on the screw thread
pressing the On/Off push button or wait about 60 seconds
or on the gasket.
after which the dishwasher will automatically return to
setting mode.5.Screw on the cap tightly
turning it clockwise until it
stops with a click.SR14
The salt container will require topping up periodically. You are
reminded of this by the salt indicator light on the control panel
which comes on when the salt has finished.
Do not worry if water over flows from the unit when filling with
salt, this is quite normal.
The salt indicator light on the control panel can remain
illuminated for 2-6 hours after the salt has been
replenished, assuming the dishwasher remains switched
on. If you are using salts that take longer to dissolve then
this can take longer. The function of the machine is not
affected.
23 |
ACEC
