¨¨¨¨
PPPPrrrriiiinnnncccceeeettttoooonnnn66665555 DDDDSSSSPPPP AAAAmmmmpppplllliiiiffffiiiieeeerrrr6
¨
Your new Princeton65 DSP amplifier deliversY Selectable Normal and Drive channels with
¨¨
world�class Fendertone and world�standard Fenderindependent volume and tone controls
DSP technology:
Y PRE-AMP OUT and POWER-AMP IN jacks
Y 65W of output power @ 8 ohms
¨
Y FOOTSWITCH jack for use with a 2-button Fender
Y Digital Signal Processingfootswitch (optional); enables remote activation of:
Y 16 FX SELECTIONS(1) Channel Select, (2) Effects
Y Separate FX LEVEL control
¨¨
Thank you for choosing FenderThank you for choosing Fender
NTNTone, Tone, Tradition and InnovationNsince 1946radition and InnovationNsince 1946
PPPPaaaannnneeeellll FFFFuuuunnnnccccttttiiiioooonnnnssss
A. INPUT - Plug your guitar in here.N. PRE AMP OUT / POWER AMP IN - (1) Effects Loop
- Connect PRE AMP OUT to an effects device input,
The Normal channel controls (B-D) are operational when the
then connect the effects device output to PWR AMP
CH SELECT button is out, or footswitch LEDJJJJ is off.
IN. (2) Multiple Amps - Connect the primary unitOs
PRE AMP OUT to the auxiliary unitOs PWR AMP IN.
B. VOLUME - Adjusts the loudness of the amplifier.The primary unit is used to control all auxiliary amps.
(3) Recording or Reinforcement - Connect PRE
C. TREBLE - Adjusts the high-frequency tone.
AMP OUT to sound equipmentOs input.
D. BASS - Adjusts the low-frequency tone.PRE AMP OUT includes onboard tone
shaping and DSP effects processing. Both jacks use
E. CHANNEL SELECT -
a TS (Tip-Sleeve) standard type plug for connections.
Button OUTselects the Normal Channel
¨
Button INselects the Drive ChannelO. FOOTSWITCH - Connect a 2-button Fender
footswitch (optional) at this jack to enable remote
switching of CH SELECT and EFFECTS. When
The Drivechannel controls (F�K), are operational when the
plugged in, the footswitch overrides the
CH SELECT buttonis in, or footswitch LEDNJJO is on.
corresponding panel controls.
F. DRIVE - Adjusts the distortion level. Use inP. POWER INDICATOR - Illuminates when the
conjunction with the Drive Channel VOLUME controlamplifier is ON.
(H) to adjust the overall loudness of the amplifier.
Q. POWER SWITCH - Switches the
G. CHANNEL INDICATOR - amplifier ON or OFF.
LED OFFQQQQNormal Channelis active
R. POWER CORD SOCKET - Connect
LED ONNQQO Drive Channel is active
the included power supply cord in
H. VOLUME - Adjusts the loudness of the amplifier inaccordance with the voltage and
conjunction with the DRIVE control (F).frequency ratings listed on the rear
panel.
I. TREBLE - Adjusts the high-frequency tone.
J. MID - Adjusts the mid-frequency tone.
K. BASS - Adjusts the low-frequency tone.
L. FX LEVEL - Adjusts the level of the selected effect.
M. FX SELECT - Selects the active effect (see next
page).
wwwwww..ffeennddeerr..ccoomm'wwwwww..mmrrggeeaarrhheeaadd..nneett |
ACEC
