(
39
&
DescriptionTwelve-stage, stereo phaser effect.
Adjustable parameters
Phaser Out Level A.djusts the wet/dry signal ratio. Select between 1.0
for 0% wet (no effect) and 10.0 for 100% wet (all effect).
$Phaser Rate (HzRange). : from 0.08 Hz to 10 Hz. Adjusts the rate of
the Phaser effect. The increment of change gradually eases from incr
0.01 Hz for the slowest rate to 0.08 Hz for the fastest rate. Remember
that the TAP button can always be used to key in the Phaser rate by
fee-l two TAP s set the time it takes for the Phaser LFOs (Low Fre-
quency Oscillators) to go through one cycle.
"Phaser Depth .Adjusts the width of the Phasand her sweep owappar-
ent the effect sounds. Select between 1.0 for no apparent effect and
10.0 for maximum effect.
#Phaser Feedback. Adjusts how much signal from the Phaser effect is
recycled back to the input. Select between 1.0 for minimum levels and
10.0 for maximum levels.
%Phaser Stereo A.djusts the amount of stereo spread in the effect.
Select between 1.0 for mono and 10.0 for temraexoimum spre sad.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
" !
/
DescriptionMono Delay plus stereo Triangle Chorus.
Adjustable parameters
FX Wet Out Level A.djusts the wet/dry signal ratio. Select between 1.0
for 0% wet (no effect) and 10.0 for a 50% mix.
$Delay Time (msRange:). 30 t1450 mo illiseconds. Adjusts the time
interval between the delayed repeats. The increment adu-of change gr
ally increases from 1 millisecond at the shortest delay time to 10 milli-
seconds at the longest delay time. RemembTAePr butthatt ton che an
always be used to key in delay times by feel.
"Chorus Depth. Adjusts the amount of Doppler shift and how apparent
the Chorus effect sounds. Select between appare1.0 fnto er fno fect
and 10.0 for maximum effect.
#Delay Feedback A.djusts the number of delay repeats. Select
between 1.0 for a single delay repeat and 10.0 for many repeats.
%Chorus Rate (Hz). Range: from 0.08 Hz to 10 Hz. Adjusts the rate of
the chorus effect. The increment of change gradually eases from incr
0.01 Hz for the slowest rate to 0.08 Hz for the fastest rate.
To use MIDI continuous &Delay Time Chang See. lectRamp or Step to change the way the
controller messages to instantly effect responds to changesDel inay T theim eparam eter. With the
change the delay timeDel, say et Ramp setting, the delay time change will be gradual with an analog
Time Change to thSte ep setting.
sounding pitch warble, (audible until the delay time stabilizes). With the
Step setting, the delay time change will be?d iigitanstaln? zt iwpith a
sound audible for a moment.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
ACEC
