6SSttaaggeeaaaa11000000 // 11660000
SSttaaggee11000000 // 11660000
¨
Your new Stagea 1000 / 1600 amplifier delivers world�class FenderY Selectable Drive 1 and Drive 2 channels for two independently
¨
tone and world�standard FenderDSP technology:adjustable distortion channels.
Y 160W output power @ 4 ohms (100W @ 8 ohms)�Y Impedance balanced XLR LINE OUT jack
Y Seven Timbre filters for total tone controlY PRE AMP OUT and POWER AMP IN jacks
Y Digital Signal ProcessingY 4-button FOOTSWITCH (included) enables remote activation of: (1)
Y Simultaneous use of Reverb and effects tone tools -Channel Select, (2) Drive Select, (3) Effects, (4) Reverb
16 REVERB TYPES and 16 FX SELECTIONS
YYBuilt in Tuner
Y Separate LEVEL and FX TIME/RATE controls
Thank you for choosing FenderThank you for choosing Fender¨¨
Y Selectable Normal and Drive channels with independent volume
The WThe WorldOorldOs most popular instrs most popular instrument amplifiersNsince 1946ument amplifiersNsince 1946
and tone controls
PPPPaaaannnneeeellll FFFFuuuunnnnccccttttiiiioooonnnnssss
A.INPUT - Plug-in connection for your guitar.B light up to indicate A sharp (B flat). The bottom row of LEDs
indicate fine tuning.
B.VOLUME - Adjusts the loudness of the Normal channel.
M.REVERB LEVEL - Adjusts the level of the active Reverb.
C.TREBLE / MIDDLE / BASS - Adjusts the high�, middle� and
low�frequency tone of the Normal channel.N.REVERB TYPE - Selects the active Reverb (see next page).
D.CHANNEL SELECT - O.EFFECTS LEVEL - Adjusts the level of the active effect.
OUT Normal channel {B�C}
P.EFFECTS SELECT - Selects the active effect (see next page).
INDrive channels {E�J}
Q.TIME/RATE - Adjusts the interval length / modulation speed of
E.DRIVE 1 - Adjusts the distortion level of the Drive 1 channel.the active effect (see next page).
F.VOLUME 1 - Adjusts the overall loudness of the Drive 1 channel.Rear Panel
G.DRIVE SELECT - PressCHANNEL SELECT {D} in to activateR.POWER SWITCH - Switches the amplifier on / off.
DRIVE SELECT.
S.POWER CORD SOCKET - Connect the included
OUTDrive 1 channel {E�F, J}power cord in accordance with the voltage and
INDrive 2 channel {H�I, J}frequency ratings listed on the rear panel of your
amplifier.
H.DRIVE 2 - Adjusts the distortion level of the Drive 2 channel.
T.PARALLEL SPEAKER OUTPUTS - Connect a single 8&
I.VOLUME 2 - Adjusts the overall loudness of the Drive 2 channel.
speaker (internal or external) to the MAIN SPKR jack. Connect
an additional 8& speaker (internal or external) to the EXT. SPKR
J.TREBLE / MID / BASS - Adjusts the high�, middle� and
jack. 4& minimum total.
low�frequency tone of the Drive channels.
Speaker(s)UseLoad / Output
K.TIMBRE - Press repeatedly to select an amp character as indicated
One 8& speakerMAIN jack8& / 100W
by the LEDs. Your selection is stored and automatically activated for
Two 8& speakersboth jacks4& / 160W
each channel (Normal, Drive 1, Drive 2).
TIMBRE FILTERS: These pre-set Equalizer curves allow theU.LINE OUT - Connect this XLR output
Dyna�Touch amps to create seven very different voices on eachjack to the input of sound reinforcement
channel. FLATNPreamp and Power Amp signal without furtheror recording equipment.
equalization. BRIGHTNTreble boost, especially effective for
V.PRE AMP OUT / POWER AMP IN -
brightening the tone of double�coil pickups. DARKNTreble cut,
Effects Loop- Connect PRE AMP OUT to an effects device input,
especially effective for traditional Jazz tones with the Normal
then connect the effects device output to PWR AMP IN.
channel. DEEPNBass boost, especially effective for beefing up
Multiple Amps - Connect the primary unitOs PRE AMP OUT to
the tone of single�coil pickups. SCOOPNA severe low�mid
the auxiliary unitOs PWR AMP IN. The primary unit is used to
scoop with bass boost designed for modern distortion tones.
control all auxiliary units.
SQUAWKNA strong mid peak reminiscent of a partially
Recording or Reinforcement - Connect PRE AMP OUT to the
depressed Wah�Wah pedal; great for distorted solos that need
input jack of sound equipment.
to cut through the mix. ACOUSTICNSimulates the sound of an
acoustic�electric guitar with extreme high treble boost and bassUse TS (Tip-Sleeve) standard type plugs with these
boost; best with the Normal channel. Note: This much Timbrejacks. The PRE AMP OUT signal includes onboard tone shaping
flexibility requires that you use a little common sense! It is
and DSP effects processing.
possible to get Otoo much of a good thing,� such as undesirable
treble harshness or bass boominess depending on yourW.FOOTSWITCH - Connect the 4-button Fender footswitch
particular guitar, playing style and knob settings.(included) at this jack to enable remote switching of CHANNEL
SELECT, DRIVE SELECT, EFFECTS and REVERB. When
L.TUNER - Activates the tuner and mutes audio output. Strike a
plugged in, the footswitch buttons override the corresponding
string and the top row of LEDs indicate the nearest note.
front panel controls.
Sharp/flat notes are indicated by two LEDs; for example, A and
wwwwww..ffeennddeerr..ccoomm'wwwwww..mmrrggeeaarrhheeaadd..nneett |