2. Onto a sink outlet spigot.Any necessary adjustment can be made with a spanner.
Accurate levelling prevents vibration, noise and
If the outlet spigot has not been used before, remove
displacement of the machine during operation.
any blanking plug that may be in place.
Some vibration is inevitable, especially if mounted on a
wooden floor.
Sprung wooden floors are particularly susceptible to
vibration. For advice, consult a builder. If possible,
always place the machine on a solid floor.
Special conditions
If the floor is carpeted or covered with crumbly or soft
material, insert a rigid support base under the feet to
prevent noise, vibration or displacement. The base
Push the drain hose onto the spigot and secure with a
should protrude a few centimetres beyond the edges of
clip if required, ensure a loop is formed in the drain
the machine.
hose (see diagram) to prevent waste from the sink
entering the washing machine.Warning
The machine should NOT be placed on deep pile
carpeting.
Note
Please ensure that when the appliance is installed it is
easily accessible for the engineer in the event of a
55
breakdown.
In the interest of the environment
The drain hose may be extended to a maximum of 4
metres. An additional drain hose and joining piece isWasher-dryers and dishwashers should be connected to
available from your local Service Force Centre. the FOUL drainage system, the water will then be taken
The joining piece must have an internal diameter ofto a sewage works for treatment before being discharged
18mm.safely into a river.
It is essential that these appliances are not connected to
Important
the surface water drainage system as this water is
IBefore connecting the machine to new pipework ordischarged directly into a river or stream and may cause
to pipework that has not been used for some time,pollution.
run off a reasonable amount of water to flush out anyIf you require any further advice please contact your
debris that may have collected in the pipes.local water authority.
Levelling
Level the appliance by raising or lowering the feet. The
feet may be tight to adjust as they incorporate a self
locking nut, but the machine MUST be level and stable.
"#$%&
)*+ (#),%(
'(")%(
$'")*-'.")*%)"$'"%&
&')*$'(%&
/&0*1#22/
2#0,&')*
0&2'.%$'(%&2#0,%$%&
&')*3%$%&
%$'%
0*(&%'(%(&%'(-%*(
)."'&%$#&+
(&%'(%
)."'&%
&)4%&&)4%&
24 |
ACEC
