SHENANDOAH? ACOUSTIC 100
OWNER?S MANUAL
ACOUSTIC
100
(FRONT PANEL)
(REAR PANEL)
PRODUCT DESCRIPTION - The Shenandoah? Acoustic 100 is configured as a 2 channel - 4 input 100 acoustic
instrument amplifier. Each channel is equipped with both a 1? unbalanced line input and an XLR balanced
microphone input (with phantom power). The 2 inputs on each channel are summed (mixed) together at a 1:1 ratio.
Each channel then passes through independent 3 band equalizers with sweep midrange frequency. Equalization
centers were carefully selected for use with acoustic instruments. Each channel also contains individual send
controls to the on -board Alesis? 15 program digital effects circuit. The channel signals are then summed together,
mixed with the digital effects return and passed on to the internal 100 watt power amplifier. The back panel contains
3 direct balanced outputs with ground lift switch, 3 unbalanced line outputs, an effects loop, effects cancel jack, and
2-1/4? speaker jacks.
INPUTS - The Shenandoah? Acoustic 100 is equipped with 2 types of input jacks. The 1? input is unbalanced and ?line
level? with a useable sensitivity from 100 mV to 1 volt. The input impedance is 150 k ohms. The 1? input will also
accept most active balanced line sources, automatically unbalancing them by recognizing the tip portion of the
balanced signal. Additionally, the precision input scaling preamp contains a 50 Hz, 12 dB/octave high pass filter
(more effective and less intrusive than the more common 6 dB filters) and an ?RFI? filter (radio frequency
interference) to eliminate unwanted noise. The XLR input jack is balanced and ?microphone level?, with a useable
sensitivity from -60dBv to -30 dBv. It contains a precision full range differential microphone preamp with phantom
power. For use with higher level sources (such as the balanced line level output from a keyboard), a balanced pad
network will be necessary to use the balanced input. Phantom power is 13.6 volts, compatible with virtually all
commonly used condenser microphones. Dynamic microphones can be used with no ill effect.
COMBINING XLR & 1? INPUTS - A unique feature of the Shenandoah? Acoustic 100 is the ability to mix the
XLR balanced and 1? unbalanced inputs on each channel. In many situations, this effectively makes the amplifier
function as a 4 channel amplifier. The most effective way to use this feature is to set the volume on the channel using
the XLR microphone input and then adjusting the level control on the instrument itself (assuming that it has one) to
blend levels between the 2 inputs. Equalization will be common to both inputs on the channel. |
ACEC
