23&/(".�?´
FUNCTION MENU
PictureFunction
Audio Screen Saver Off
TimerOK Screen Wipe On 60Min.
MENU Function Black Side Panel OffENGLISH
Setup Video Power Save Off
Language Freeze Mode Split
Select Default Zoom Panoramic
OK Set Reset Reset
Select Set Return
Function
Panel Life Normal
Mode Display Off
ID Number 1
Inverse On 60Min.
Standby White Off
Gamma 2.2
Reset Reset
Select Set Return
Selected charactersSetup hint
This moves the picture around the screen in small amounts, at set
Off 5Min. 10Min.intervals, to reduce the panel image retention. This is where
Screen Saver
60Min. 40Min. 20Min.stationary objects, such as screen logos, leave a slight image visible
after they should have disappeared.
This is used to reduce the panel image retention that can occur with
stationary pictures by the white field signal. Select On (continuous
Screen WipeOn60Min.operation) or 60 Min. (time limit operation) and press the OK button.
Press the MENU or RETURN button on the remote control to return to
normal viewing.
This turns the gray sidebars On/Off when watching normal mode
screen size area. It is always set to Off when the monitor powered
Black Side PanelOff On
On. It is recommended to set to Off to reduce the panel image
retention.
Video Power SaveOptional (grayed out)
Freeze ModeOptional (grayed out)
Default ZoomOptional (grayed out)
The original factory settings for the items of this Menu page can be
Reset(off the function)(waiting to reset)
restored by pressing the OK button.
This function is to suppress the contrast of the screen regardless of
the Contrast setting in the Picture Menu. By this control, power
consumption can be reduced or degradation of a panel can be
Normal Extend 1 Extend 2
Panel Lifemitigated. The order of power consumption is Extend 2 < Extend 1 <
Normal.
If the Contrast setting is changed when this item is set to Extend 1 or
2, it will be changed to Normal automatically.
This can display the Input Signal Screen Display every time the input
mode and signal mode are changed.
Mode DisplayOff On
Set to OFF if the Input Signal Screen Display is not needed when
switching signals.
1 2 3 4Assigns ID nos. to the monitors so that they can be controlled
ID Number
individually (up to 7 monitors can be controlled).
7 6 5
This function can change each level of RGB signal invert to reduce
the panel image retention. When this function is required to use,
InverseOn60Min.
select On (continuous operation) or 60Min. (time limit operation) and
press the OK button. And press the Menu or Return button to exit.
This function is also provided against the image retention. If time is
Off 15Min. 30Min.set for this item, the screen changes into the white pattern when the
Standby White
120Min. 60Min.monitor enters power save mode, and it will continue for the period of
setting time.
Gamma2.2 2.8Normally set to 2.2.
19 |