01_QR64181_EN 4/18/05 12:27 PM Page 41
TV SETUP OPERATION (continued)
SETUP MENU (Video mode)
PictureSetupSetup
Audio System System 1 Colour System
Timer Colour System
MENU Function Video Input AV1 Auto
Setup Scart Output Monitor AV2 PAL
Select RGB1 DVI-STB AV3 PAL
OK Set RGB2 Component AV4 Auto
HDTV
Select Set ReturOKn Select Return Exit
SetupSetup
System System 1 Video Input
Colour System
Video Input AV1 Composite
Scart Output Monitor AV3 Auto
RGB1 DVI-STB
RGB2 Component
HDTV
Select Set ReturOKn Select Return Exit
Selected charactersSetup hint
SystemSystem1 System2Do not change the original setting.
(System1 : Europe/Asia, System2 : North America)
Colour System
System1This should correspond to the colour system of the signal from the
equipment that is connected to AV1~AV4 video input terminal.
Auto PAL SECAM
Y Normally, set this to Auto. The system of the input signal will be
NTSC3.58 NTSC4.43automatically recognized.
AV1~AV4
Y If the input signal contains much noise or has a low level at Auto and
System2
the operation is found erratic, set this to match the input signal.
Auto NTSC-MY When the component signal is received, this would be not available
PAL-N PAL-M(greyed out).
Video Input
This should correspond to the signal mode of the signal from the
AV1S.Video Composite
equipment that is connected to AV1 Scart input.
This should correspond to the signal mode of the signal from the
equipment that is connected to AV3 video input terminal.
Y Normally, set this to Auto. The signal mode of the input signal will be
AV3Auto HDTV SDTV/DVD
automatically recognized.
Y If the input signal contains much noise or has a low level at Auto and
the operation is found erratic, set this to match the input signal.
DTT : AV1 (Scart) output will be fixed as DTT signal output.
TV:AV1 (Scart) output will be fixed as TV signal output.
Monitor:AV1 (Scart) output can view the image as on the main unit. But it
Scart OutputDTT TV Monitor
is possible to monitor only the composite video signal from AV2, AV3, or
AV4 input that is displayed on the screen at the time.
Y If Descrambler is set to On, it will be fixed as TV automatically.
This should correspond to the signal mode of the signal from the
RGB1DVI-PC DVI-STB
equipment that is connected to RGB1 DVI terminal.
This should correspond to the signal mode of the signal from the
RGB2 (1st step)RGB Component
equipment that is connected to RGB2 D-sub terminal.
This step should be set only when [Component] is selected on the 1st
step.
This should correspond to the signal mode of the signal from the
equipment that is connected to RGB2 D-sub terminal.
RGB2 (2nd step)Auto HDTV SDTV/DVD
Y Normally, set this to Auto. The signal mode of the input signal will be
automatically recognized.
Y If the input signal contains much noise or has a low level at Auto and
the operation is found erratic, set this to match the input signal.
41 |
ACEC
