USING THE REMOTE TO CONTROL VCR FUNCTIONS
Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your VCR.
(refer to page 42 for pre-codes)
1. Turn ON your VCR.
2. Aim the remote control at the front of your VCR.
3. Press and release the VCR button to switch to VCR pre-coded mode.
4. Hold down the VCR button on the remote and enter the two digit preset code that matches your VCR, as shown on page 42. The
indicator light will flash 3 times if the code was accepted.
5. Aim the remote at the VCR and press the POWER button. The remote will turn off your VCR when the correct two digit preset code
is entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off, try a different two digit
preset code.
6. The remote will now control your VCR.
POWER
TVVCRCBLSTB
SOURCE WIZARD
DVDCDTAPEAMP
NOTES:
123
1. If your VCR cannot be operated after performing the
above procedures, your VCROs code has not been456
precoded into the remote.789
2. In the unlikely event that your VCR cannot be operated
SLEEP0INFO
after performing the above procedures, please consult
ANTA/V NETGUIDEASPECTVIRTUAL HD
your VCR operating guide.
3. The remote control will remember the codes you have
EXIT
programmed until the batteries are removed from theMENU
remote control. After replacing the batteries repeat the
VOLSELECTCH
entire programming procedure as stated above.
4. The MENU button will act as the VCR MENU button for
HITACHI VCRs.SVCSMUTELAST CHSCHD
5. The LAST CH button will act as your VCR ENTER buttonVID 1VID 5
VID 2VID 4
if required.VID 3
PIPPIP CHFREEZE
6. The SLEEP button will act as your VCR �100O button if
PIP ACCESS
required.PIP MODESWAPVIDEO
VCR Button
This button allows the remote to control your VCR by setting
it to VCR mode.REC
PRECODED VCR Buttons
These buttons transmit the chosen precoded VCR codes.
For some VCRs, you must press the RECORD button twiceCLU-5721TSI
to record a program.
EXCLUSIVE TV Buttons
These buttons are for operating the TV.
MY VCR CODE IS:
NOTE:Refer to instruction manual of the VCR for operation of the buttons exclusively for the VCR.
36 |
ACEC
