VIDEO
Manual Convergence Adjustment Mode
NOTES: 1. Please turn ON your television for at least 20 minutes before using this feature.
2. Auto Adjustment Mode is recommended. If convergence is still not acceptable, use the Manual Adjustment Mode.
DO NOT press MAGIC FOCUS or use Auto Adjustment Mode after using Manual Adjustment Mode.
Using the Remote Control, select VIDEO-MAGIC FOCUS-MANUAL ADJUSTMENT MODE to access convergence crosshatch pattern.
The adjustment point is indicated by the Adjustment Point Cursor.
To Move Adjustment Point
To move adjustment point, the Adjustment Cursor must be WHITE. Use the THUMB STICK to move the Adjustment Cursor. Another
way to move the Adjustment Point Cursor is to press the followiing buttons: [2] up, [4] left, [5] down, [6] right. If you use the number
buttons while the adjustment point is WHITE, it will change to RED.
To Change the Color of Adjustment Point
Press the SELECT button repeatedly (WHITE-RED-BLUE-WHITE...). Green color is fixed and cannot be adjusted.
To Adjust the Convergence
Move the Adjustment Cursor to the point to be adjusted. Use the THUMB STICK to match the RED and BLUE colors to GREEN
(reference color). Properly aligned, all three colors should appear white.
VideoVideo
AudioPicture ModeSports
Ch. ManagerContrast100%
LocksTHUMBTHUMBBrightness50%
STICKSTICK
Color50%
Setup
SELECTTint
MENUMoveSELSelSharpness50%
Vertical Position
Magic Focus
Color System
Advanced Settings
MoveSEL Select
THUMB
STICK
SELECTAdjustment Point
Cursor
Video
Magic Focus
Aligns the Red, Green, and Blue
colors to correct for Magnetic
Influences.THUMBTHUMB
STICKSTICK
Adjustment Mode
AutoSELECT
Manual
If you want to adjust nowStart
MoveSEL Select
If convergence is acceptable after Manual Convergence adjustment, press EXIT button to access menu mode.
DONE: [1]
EXITCANCEL: [2]
INI. RESET : [3]
BACK: [4]
Press the [1] button on the remote control to SAVE adjusted data and return to main picture.
Press the [2] button on the remote control to CANCEL adjusted data and return to main picture.
Press the [3] button on the remote control to recall the factory pre-set convergence data.
Press the [4] button on the remote control to return to the manual convergence adjustment mode (crosshatch pattern).
Press the [9] button on the remote control to read the SAVED data.
43 |
ACEC
