SETUP
NOTES:1. Auto Channel Scan must be performed first when using ANT C for the first time.
2. When in ANT C, only channels stored in Channel Manager during Auto Channel Scan can be tuned using the
number buttons on the remote control (see pages 54-55, and 65).
3. When Source-Cable is selected, performing Auto Channel Scan in ANT C will also store scrambled channels in its
memory. These channels will be shown as blank on the screen when the channel selector buttons on the remote
control are used. Please use CHANNEL MANAGER menu to skip (Scan - Off) these scrambled channels
(see page 54).
4. Turning the power off while executing Auto Channel Scan will only store channels scanned before the power
interruption.
5. If your ANT C source is an antenna, repeat Auto Channel Scan everytime antenna position/direction is changed.
6. Channel availability in ANT C depends on the broadcaster. Certain channels that are available during the day may
not be available at night.
Set The InputsUse this feature to give a name to any of the five video inputs.
SetupSetup
Menu PreferenceSet The Inputs
Set The ClockVideo1 Rename
Set The ChannelsTHUMBVideo2 Rename
THUMB
STICKSet The InputsSTICKVideo2 Auto Link
Set Event TimerVideo3 Rename
MENUSELECT
Set Closed CaptionsVideo4 Rename
Set Monitor OutVideo5 Rename
Upgrades
IEEE-1394
About Your TV
MoveSEL SelectMoveSEL Return
THUMB
STICK
SetupSetup
Set The InputsSet The Inputs
Video1 RenameVideo 1 Rename
Video2 RenameTHUMBList
STICK
Video2 Auto LinkCAMDVD2VCR
Video3 RenameSELECT
CBLLDVCR1
Video4 Rename
DVDSATVCR2
Video5 Rename
IEEE-1394DVD1STBReset
MoveSEL Select
MoveSEL Return
Press THUMB STICK , , , , to highlight the name of the video inputs.
Press down on THUMB STICK to select desired input name.
Select RESET to set video names to original factory preset condition.
66 |
ACEC
