2- To switch on the TV from stand-by mode either:
Before Switching on your TVPress a digit button on the remote control so that a pro-
Power connectiongramme number is selected,
or,
IMPORTANT: The TV set is designed to operate on
220-240V AC, 50 Hz.Press Programme Up and Down buttons on the front of
After unpacking, allow the TV set to reach the ambientthe TV or on the remote control respectively, so the TV
will switch on and the RED Led will turn GREEN.
room temperature before you connect the set to the
mains.To switch the TV off
Aerial Connections Press the stand-by button on the remote control, so
Connect the aerial plug to the aerial input socket lo-the TV will switch to stand-by mode and the GREEN
LED will become RED, or,
cated at the back of the TV. Press the power button located on the front of the
How to connect other devicesTV.
IMPORTANT: Switch off the TV before connecting any
external device.Operating the TV
Sockets for external connections are on the back of theYou can operate your TV in two ways. First by using
TV.the remote control handset and second by using
For connection of other devices via SCART connectorthe controls on the TV.
(or RCA Jack) refer to the manuals of the related de-APS (Automatic Programming System)
vices.
Inserting batteries in the remote controlThe Auto programming system automatically
programmes your TV according to the correct transmis-
handsetsion system in your area.
Remove the battery cover located on the back of theWhen you turn on your TV for the first time, the "Auto
handset by gently sliding it in the direction shown be-Setup'' menu will be displayed. In this menu if the lan-
low.guage setting is incorrect, use either ? ? or ? ? but-
Insert two MN2400 AAA or equivalent type batteriestons to highlight "Language'' and select the most suit-
inside.able language using the ? ? or ? ? buttons. Then use
Replace the battery cover.either of the ? ? or ? ? buttons to highlight "Country".
If the country setting is incorrect, use either of the ? ?
or ? ? buttons to select the correct one. Finally use
? ? or ? ? buttons to highlight " Start" and press ei-
ther of the ? ? or ? ? buttons to start the "Auto-Pro-
gramming''. The "Auto-Programming system'' (APS)
can be cancelled by pressing the "TV'' button located on
the remote control handset.
Note: Remove the batteries from the remote control
handset when it is not going to be used for a long time.
Otherwise it could be damaged if the batteries leak.
Switching the TV ON/OFF
You can operate your TV either using the remote
control handset or directly using the buttons on
the TV.
To switch the TV on
Your TV will switch on in two steps:When the APS has finished a table of stored stations will
be displayed on the screen with number 1 highlighted in
1- Press the power button located on the front of the red. In the table you will see programme numbers andTV.
Then the TV switches itself to standby mode and thenames assigned to the stations, they will be listed in a
RED LED located below the TV turns on.predetermined order.
GB - 9 - |
ACEC
