OPERATING INSTRUCTIONS
Turning Power On and Off
ENGLISHTo turn on the set power supply, set the MAIN POWER switch ( ) of the main unit to ON and then
press the SUB POWER button or the POWER button of the remote control.
To turn off the set power supply, press the SUB POWER button of the main unit or the POWER button
of the remote control, then set the MAIN POWER switch ( ) to OFF.
For normal operations, leave the main power switch ( ) set to ON and use the sub power switch or
the Power button of the remote control to turn the power on and off.
Display lampPower statusOperating
OffOffWhen the main power switch is set to OFF.
When the main power switch is set to ON
and Power button of the remote control or the
Lights redOff (standby)*
sub power button on the control panel located
at the front part of the bottom plate is off.
When the main power switch is set to ON
and Power button of the remote control or the
Lights or blinks greenOn
sub power button on the control panel located
at the front part of the bottom plate is on.
When the indicating lamp blinks in green or the message OPOWER
SAVE� or OOUT OF FREQUENCY� appears on the screen, there is
Main power
something unusual about the status of reception. See OSymptoms Thatswitch
Seemingly Appear to be Failures.�
SUB-POWERPOWER
* The Ostandby� mentioned here is different from the Ostandby� in PowerSet unitRemote
controller
Saving System .
Avoid repeatedly turning the monitor on and off at short time intervals.
Failures might result from such operation.
Turn off the main power switch ( ) before leaving the monitor out of use
TIPS
for an extended period of time.
If a power failure occurs while the set is running, it would be powered on upon
recovery from the failure. Turn off the unit main power switch before leaving the set. |
ACEC
