Installation on the plasma display
Perform installation according to the following steps 1 to 3.
NOTE:
After this unit has been installed on the plasma display, you can't use the display operation panel. Please use the remote control
supplied with the display.
1. Attach the mounting plates to this unit3.Install this unit on the display side
As in the illustration below (right speaker only), when lookingInstall the unit marked "RIGHT" on the right side of the
from the rear, attach the right mounting plate to the right handdisplay.
side of the right speaker. For the left speaker, attach the left
mounting plate to ther left hand side. Plasma display
Adjust the mounting plate to about 0.5 cm
below the upper edge of the speaker.
Seal
Mounting plate
Seal
Mounting plateHexagon
1. Match the speakers and the socket head
screw
mounting plates so that the
correct combination of left and
right is obtained.
2. Peel the seals from the adhesive
surfaces of the mounting plates.
3. Confirm the installation positionInstall the unit marked "LEFT" on the left side of the display.
and attach the mounting plate to
the inside of the speaker.
Plasma display
Seal
2. Install the mounting fittings on this unit
The illustration shows an example for this unit (right side).
Mounting plate
For top side
Hexagon
1 The top side fittings aresocket head
different for the right and thescrew
left side, and they must be
matched correctly.
2 Install the mounting fittings
with bolts at the positions
Flat countersunk
shown in the figure on the
head screwleft.1. Check the indications LEFT and RIGHT at the rear of the
speakers, observe the indication "UP ", and fasten the
upper mounting fitting provisionally to the display. Then
install the lower fitting on the display.
2. Adjust the position so that the gap between the speaker
and the display is uniform, and then tighten the screws
For bottomfirmly.
47 |
ACEC
