CPS210 (C10S)
CP-S210 (C10S)
6-10 Related Messages
22
message is displayed on the screen, please respond as described below.
MessageDescription
CHANGE THE LAMPLamp usage time is approaching 2000 hours. (*2)
AFTER REPLACING LAMP,22
RESET THE LAMP TIMER.changed the lamp, please be sure to reset the lamp timer.
(*1)
CHANGE THE LAMPLamp usage time is approaching 2000 hours. (*2)
AFTER REPLACING LAMP,A lamp change within ** hours is recommended. When lamp usage reaches 2000 hours,
RESET THE LAMP TIMER.22
"Lamp" section of this manual. After you have changed the lamp, please be sure to reset
THE POWER WILL TURN OFF
the lamp timer.
AFTER ** hr(*1) .
CHANGE THE LAMP22
AFTER REPLACING LAMP,OFF.
22
RESET THE LAMP TIMER.
section of this manual. After you have changed the lamp, please be sure to reset the lamp
THE POWER WILL TURN OFF
timer.
AFTER 0 hr.
NO INPUT IS DETECTEDThere is no input signal.
ON ***Please conrm the signal input connection, and the status of the signal source.
The horizontal or vertical wavelength of the inputted signal is outside of the response
SYNC IS OUT OF RANGE
parameters of this unit.
ON *** fH *****kHz fV *****Hz
Please conrm the specs for this unit or the signal source specs.
The internal portion temperature is rising.
Please turn the power OFF, and allow the unit to cool down at least 20 minutes. After
having conrmed the following items, please turn the power ON again.
CHECK THE AIR FLOW
Is there blockage of the air passage aperture?
Is the air lter dirty?
Does the peripheral temperature exceed 35C?
A note of precaution when cleaning the air lter.
CLEAN THE AIR FILTER
22
POWER OFF FIRST,
to the "Air Filter" section of this manual. After you have cleaned or changed the air lter,
THEN CLEAN THE AIR FILTER.
please be sure to reset the lter timer.
AFTER CLEANING
22
THE AIR FILTER,
of żlter cover and the dust-detecting window, according to the following "Caring Of The
RESET THE FILTER TIMER.
Transparent Area Of Filter Cover and The Dust-detecting Window" .
Note2:2
reappeared every time the power is turned ON.
(*2) Lamps have a finite product life. Lamps are characterized by the fact that, after long hours of usage, a
lamp will no longer light up, or the lamp will break or burst, etc. This unit is equipped with an automatic shut-
down function, such that the power will automatically be turned OFF when lamp usage time has reached 2,000
hours. Please be aware, however, that among lamp types, there are major differences in product lifetimes; a
lamp may thus fail to light even prior to the functioning of the automatic shut-down function of this unit.
Caring Of The Transparent Area Of Filter Cover And The Dust-detecting Window
The transparent area of filter cover and the dust-detecting window should be cleaned for normal operation of the
optical dust detecting system. Please pay attention not to remain fiber or fragment of cloth inside the duct.
Filter cover
1. Turn off the projector, and unplug the power cord.Filter cover
2. After making sure that the projector has cooled
22
Hold the release buttons of the żlter cover, while
pulling up it.
3. Wipe the transparent area of the lter cover by using Release buttonsTransparent area
a swab or a soft cloth.Release buttons
4. Remove the air lter.
Hold the release buttons of the air lter, while pulling
down it.
5.Wipe the dust-detecting window by using a soft cloth.
Dust detecting
Air filter(Rear side)
6. Replace the air lter and lter cover.(Bottom side)window
2226 |
ACEC
