324.5mm
Pulley
38mm
B shaft5960 60
Thrust washer575858 Rotary brush54 55 55BB cover5859 59
BB cover5859 59
Thrust washer5758 58
End cap Assembly5556 56
End cap Assembly555656 Ball bearing BB 626 ZZ5657 57
Ball bearing BB 626 ZZ5657 57
Fig.2
(5) Lift the hose supporter(48)(49)(49) from the nozzle cover(30)(31)(31),and take off the hose supporter from the duct
hose(73)(74)(73).
(6) To remove the duct hose from the joint(71)(72)(71),twist the duct hose clockwise,and pull it out.
(7) Take off the two tapping screws 4? 20(70)(71)(70),the pedal ass'y(65)(66)(65) can be removed.
(8) Take off the two tapping screws 4? 25(52)(53)(53),then the supporter(R)(51)(52)(52) can be removed.
(9) Pull the supporter(L)(50)(51)(51) out from the nozzle cover, then the nozzle cover can be removed from the main
case ass'y.
3.2 HOW TO DISMANTLE MAIN CASE ASSEMBLY,POWER CONTROL/TRIAC PWB,
AND MOTOR ASSEMBLY
(1) Disconnect the plug of the cleaner from the electrical outlet.
(2) Undo the clamp(2) and detach the bag compartment lid assembly(1),from the cleaner body.
(3) Remove the attachments.
(4) CV-80D
Take off the three tapping screws 4x25(78) and the line head screw 4x25(76) by using the special screw driver
(96),then the upper cover (26) can be removed. Take off the two tapping screws 4? 16(80) and the cord
stopper(81),then the power cord(75) can be removed from the main case by taking off the lead wire from the
terminal block(82).
CV-80DC,DP
Take off the three tapping screws 4x25(81)(80) and the line head screw 4x25(79)(78) by using the special screw
driver (101)(101),then the upper cover (26)(26) can be removed. Take out the power control PWB(99)(99) and the
triac PWB(100)(100) from the main case. Take off the two tapping screws 4? 16(83)(82) and the cord
stopper(84)(83),then the cord(77)(76) can be removed from the main case by taking off the lead wire from the
terminal block(85)(84).
(5) Open the front cover and remove the filter from the cleaner.
(6) Take off the four tapping screws 4x25(79)(82)(81), then the lower cover(60)(61)(61) can be removed.
(7) Remove the motor assembly(33)(34)(34)by pulling it out.
-3- |
ACEC
