NOTE:UnitmustbeplacedonitssidewhenSTARTING A COLD ENGINE (or a
adding fuel (see illustration below).warm engine after running out of fuel)
1. Move throttle lever to theposition.
2. Move choke lever to the FULL CHOKE
position.
3. Slowly press the primer bulb 8 times.
Throttle LeverPrimer Button
Choke Lever
4. Pull starter rope sharply until engine at-
tempts torun,butnomorethan5pulls(be-
low 0_ C, 8 pulls).
NOTE:Ifengineattemptstostartbeforethe
5th pull, go to next step immediately.
STOPPING YOUR ENGINE
5. Move the choke lever to the HALF
DTostoptheengine,movethethrottleleverCHOKE position.
to the STOP position.6. Pull the starter rope sharply until the en-
gine runs, but no more than 5 pulls (below
BEFORE STARTING THE ENGINE0_ C, 10 pulls).
7. Run engine for 5 seconds, then move
WARNING:YouMUSTmakesurethechoke lever to the RUN position.
tubes are secure before using the unit.8. Allow the unit to run for 30 more seconds
DFuelengine.Moveatleast3metresawayat the RUN position before moving the
from the fueling site.throttle lever to theposition.
DHoldtheunitinthestartingpositionas
Ifenginehasnotstartedafter5pulls(atHALF
shown. Make sure the blower end is di-CHOKE), repeat STARTING A COLD EN-
rected away from people, animals, glass,GINE procedure. If engine still does not start,
and solid objects.proceed to STARTING A FLOODED EN-
GINE.
STARTING POSITION9. To stop the engine, move the throttle lever
to the STOP position.
STARTING A WARM ENGINE
1. Move throttle lever to theposition.
2. Pull starter rope sharply until engine runs
but no more than 5 pulls.
NOTE:Ifenginehasnotstarted,pullstarter
rope 5 more pulls. If engine still does not run,
Blower
it is probably flooded.
3. To stop the engine, move the throttle lever
to the STOP position.
VacuumSTARTING A FLOODED ENGINE
Flooded engines can be started by placing
the choke lever in the RUN position. Move
throttle lever to the fast position; then,
WARNING:Whenstartingengine,pull rope until engine starts. After engine
starts,movethethrottlelevertotheslowposi-
hold the unit as illustrated. Do not set unit on
any surface except a clean, hard area whentionto allow engine to idle.
startingengineorwhileengineisrunning.De-Starting could require pulling the starter rope
bris such as gravel, sand, dust, grass, etc.many times depending on how badly the unit is
could be picked up by the air intake andflooded.
thrown out through the discharge opening,If unit still doesn?t start, refer to the TROUBLE-
damagingtheunitorproperty,orcausingseri-SHOOTING TABLE or contact an authorized
ous injury to bystanders or the operator.service dealer.
-- 7 -- |
ACEC
