ASSEMBLY
Fitting the loop handleAssembling and dismantling the
(325Cx)two-piece shaft
(323LD, 325LDx)
? Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.
Assembly:
? Make sure the knob is loose.
? Fit the screw, securing plate and wing nut as shown in the
diagram.
? Tighten the wing nut.? Align the cut-out in the lower part of the shaft with the
coupling locking tab on the upper part of the shaft. Then
lock the sections together.
Fitting the loop handle? Tighten the knob.
(323L, 323LD, 325Lx, 325LDx)
? Clip the loop handle onto the shaft. Note that the loop
handle must be Ţtted between the arrows on the shaft.
Dismantling:
? Undo the knob (at least three turns).
? Slide the spacer into the slot in the loop handle.? Push the knob towards the coupling.
? Carefully twist the lower half of the shaft to unlock it.
? 323L/323LD: Fit the nut, washer and screw.
325Lx/325LDx: Fit the nut, knob and screw. Do not ? Hold both parts of the shaft and pull the lower part of the
overtighten.shaft out of the coupling.
? Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.
10 - English |
ACEC
