START AND STOP
Control before startingWarm engine
IGNITION:
YInspect the working area. Remove objects that can beSet the stop switch to the
thrown.
start position.
Y Check the blades. Never
use blades that are dull,
cracked or damaged.CHOKE:B
Set the choke control in the
Y Check that the hedgechoke position and then
trimmer is in fullback again to its original
working order. Checkposition (B)
that all nuts and bolts areIn this way only the start
tightened correctly.throttle is applied with no
YMake sure the gearbox is lubricated correctly. See thechoke.
section �Lubricating the blades�.
AIR PURGE:
YEnsure the blades always stop when the engine is idling.
YOnly use the machine for what it is intended for.Press the air purge dia-
phragm repeatedly until fuel
YEnsure that the handle and safety functions are in order.begins to fill the diaphragm.
Never use a machine that lacks a part or has been modified
The diaphragm need not be
outside of the specifications.completely filled.
Start and stop
Start
Press the machine bodyWARNING!
against the ground using yourThe gearbox and clutch drum must be
!fitted before the machine is started,left hand (NOTE! Do not use
otherwise the clutch can become looseyour foot). Grip the starter
and cause personal injury.handle with your right hand
and slowly pull the starterAlways move the hedge trimmer about 3
cord out until you feel somemetres from the filling position before the
machine is started. Place the machine onresistance, (the starter hooks
a hard surface. Bear in mind that thegrip) now quickly and
blades could start to move when thepowerfully pull the cord.
engine starts. Make sure the bladesImmediately press the choke
control in when the enginecannot come into contact with any object.
fires and repeat until theMake sure that no unauthorised persons
are in the working area, otherwise there is
engine starts. When thea risk of serious personal injury.
engine starts, quickly apply
full throttle and the start
Cold engine
throttle will automatically
IGNITION:disengage.
Set the stop switch to the
start position.NOTE! Do not pull the
starter cord out completely
A
CHOKE:and do not release the starter
Set the choke control in thecord from the fully extended
choke position (A).position. This can damage the
The choke position is alsohedge trimmer.
the automatic start throttle
position.
Stop
The engine is stopped by
AIR PURGE:
switching the ignition offPress the air purge dia-
using the stop switch.phragm repeatedly until fuel
begins to fill the diaphragm.
The diaphragm need not be
completely filled.
English � 13 |
ACEC
