STARTING AND STOPPING
Check before startingStarting and stopping
? Check the blade to ensure that no cracks have formed at
the bottom of the teeth or by the centre hole. The most WARNING! The complete clutch cover and
common reason why cracks are formed is that sharp shaft must be Ţtted before the machine is
corners have been formed at the bottom of the teeth while !started, otherwise the clutch can come loose
sharpening or that the blade has been used with dull and cause personal injury.
teeth. Discard a blade if cracks are found.
Always move the machine away from the
refuelling area before starting. Place the
machine on a �at surface. Ensure the cutting
attachment cannot come into contact with
any object.
Make sure no unauthorised persons are in
the working area, otherwise there is a risk of
? Check that the support �ange is not cracked due to fatigue serious personal injury. The safety distance
or due to being tightened too much. Discard the support is 15 metres.
�ange if it is cracked.
Starting
Primer bulb: Press the air purge repeatedly until fuel begins
to Ţll the bulb. The bulb need not be completely Ţlled.
? Ensure the locking nut has not lost its captive force. The
nut lock should have a locking force of at least 1.5 Nm.
The tightening torque of the locking nut should be 35-50
Nm.
Choke: Set the choke control in the choke position.
? Check that the blade guard is not damaged or cracked.
Replace the blade guard if it is exposed to impact or is
cracked.
? Check that the trimmer head and trimmer guard are not WARNING! When the engine is started with
damaged or cracked. Replace the trimmer head or !the choke in either the choke or start throttle
trimmer guard if they have been exposed to impact or are positions the cutting attachment will start to
rotate immediately.
cracked.
Hold the body of the machine on the ground using your left
hand (CAUTION! Not with your foot!). Grip the starter handle,
slowly pull out the cord with your right hand until you feel
some resistance (the starter pawls grip), now quickly and
powerfully pull the cord. Never twist the starter cord around
your hand.
Repeat pulling the cord until the engine starts. When the
? Never use the machine without a guard nor with a engine starts. return choke control to run position and apply
defective guard.full throttle; the throttle will automatically disengage from the
? All covers must be correctly Ţtted and undamaged before start setting.
you start the machine.
English - 15 |
ACEC
