FUEL HANDLING
Chain oilFuelling
Y The chain lubrication
system is automatic. Always
Taking the following precautions, will lessen
use special chain oil with
the risk of fire.good adhesive
characteristics.
Y Do not smoke or place warm objects in the vicinity of
the fuel.
Y In countries where no
Y Always shut off the engine before refuelling.
special chain oil is available,
Y Slowly open the fuel cap, when filling fuel, so that
EP 90 transmission oil can
possible overpressure is slowly released.
be used.
Y Tighten the fuel cap carefully after fuelling.
Y Always move the saw from the fuelling area before
Y Never use waste oil. This
starting.results in damage to the oil
pump, the bar and the
chain.
WARNING!
Y It is important to use oil ofThe catalytic converter muffler gets very hot
the right viscosity accordingduring and after use. This also applies during
to the air temperature.idling. Be aware of the fire hazard, especially
when handling the saw near flammable
o
Y In temperatures below 0Csubstances or vapours.
(32oF) some oils become
too viscous. This can
Clean around the fuel cap.
overload the oil pump and
Clean the fuel and chain oil
result in damage to the oil
tanks regularly. The fuel filter
pump components.
should be changed at least
once a year. Contamination in
Y Contact your servicing
the fuel tanks causes
dealer when choosing chain
malfunction. Make sure the
oil.
fuel is well mixed by shaking
the container before fuelling.
The volume of chain oil and
fuel tanks are adjusted to
each other. Therefore, always
fill chain oil and fuel at the
same time.
Min 3 m
(10ft)
English � 27 |