STORAGE
Winter storageTo ready the machine for storage, follow these
steps:
At the end of the season, the machine should be
1. Clean the machine carefully, particularly the
readied for storage (or if it will not be in use for
chassis and working equipment. Mend damage
longer than 30 days). Fuel allowed to stand for long
to the paint to prevent rust.
periods of time (30 days or more) can leave sticky
residues that can plug the carburetor and disrupt2. Inspect the machine for worn or damaged parts
engine function.
and tighten any nuts or screws that may have
become loose.
Fuel stabilizers are an acceptable option as regards
sticky residues during storage. If alkylate gasoline
3. Change the engine oil; dispose of properly.
(Aspen) is used, stabilizers are unnecessary
4. Open the fuel valve. Empty the fuel tank (1) and
because this fuel is stable. However, you should
the carburetor (2).
avoid switching between regular and alkylate
gasoline as sensitive rubber components can
harden. Add stabilizer to the fuel in the tank or in
the storage container. Always use the mixing ratios
specified by the manufacturer of the stabilizer. Run
the engine for at least 10 minutes after adding the
stabilizer so that it reaches the carburetor. Do not
empty the fuel tank and the carburetor if you have
added stabilizer.
8011-048
WARNING!
Never store an engine with fuel in
the tank indoors or in poorly5. Close the fuel valve.
ventilated spaces where fuel
6. Remove the spark plug and pour about a
vapor can come in contact with
tablespoon of engine oil in the cylinder. Turn
open flame, sparks or a pilot light
over the engine so that the oil is evenly
such as in a boiler, hot water tank,
distributed and then refit the spark plug.
clothing drier, etc. Handle the fuel
Put the engine in the compression phase where
with caution. It is very flammable
the triangle mark on the sleeve of the starter is
and careless use can cause
aligned with the upper hole in the starter.
serious damage to person and
Note: Compression phase occurs every second
property. Drain the fuel into an
revolution.
approved container outdoors and
far away from open flame. Never
use gasoline for cleaning. Use a
degreaser and warm water instead.
8011-049
Service
When ordering spare parts, please specify the
7. Lubricate all grease nipples, joints and shafts
purchase year, model, type, and serial number.
as described in the chapter �Lubrication/
Always use genuine Husqvarna spare parts.Lubrication schedule�.
An annual check-up at an authorized service8. Store the machine in a clean, dry place and
workshop is a good way to ensure that your machinecover it for extra protection.
performs its best the following season.
English � 45 |
ACEC
