OPERATION
To attach jumper cables
YConnect each end of the RED cable to
the POSITIVE (+) terminal on each
battery, taking care not to short against
chassis.
YConnect one end of the BLACK cable to
the NEGATIVE (-) terminal of the fully
charged battery.
YConnect the other end of the BLACK
cable to a good CHASSIS GROUND on
the mower with the discharged battery,
away from the fuel tank and battery.
To remove cables, reverse order
YRemove BLACK cable Ţrst from chassis
and then from the fully charged battery.
YRemove RED cable last from both
batteries.
Running
1. Release the parking brake by moving the
lever forward.
Your mower is equipped with an operator
presence system. When the engine is
running, any attempt by the operator to
leave the seat without Ţrst setting the
park brake will shut off the engine.
2. Move the steering controls to the neutral BAM-4
position (N).Released parking brake
3. Select the cutting height by placing the
peg in one of the holes. Lock the peg on
the inside with the pin.
4. Press in the stop handle, counter hold,
and carefully move the lifting lever
forward from the transport position
toward the peg.
IMPORTANT INFORMATION
The mower deckOs anti-scalp rollers should
be evenly adjusted. See Maintenance CUTTING HEIGHT
section.Cutting height selection
English-30 |
ACEC
