HUSQVARNA BZ27C Instruction Manual

Deck Leveling Combi Deck
Locate the three deck leveling blocks from the
loose parts.
Deck Leveling Block
Raise the front of the deck and position the
blades so they are parallel with the sides of
the unit.
Place one (1) height block under the front of
the center blade on the mower deck. The
blade tip should rest on the lower level of the
spacer block
(single hole level).
Raise the rear of the deck and place one
12
spacer block under the rear of each outer
blade set at the higher level of the spacer Adjust Deck Using Deck Leveling Blocks
block (dual hole level). This will put the deck at 1. Front Block
a slight angle tilting slightly lower toward the
front.2. Rear Block
The deck will be set at 5.7 cm (2.25�) with the
correct pitch.
2
Lower the deck lift lever to 5.7 cm (2.25�). The
lift lever may have to be held down to prevent
spring back.1
Connect the chains to the deck. Make sure to
remove all slack from the chains by holding
the mounting hardware toward the bottom of
the slot while tightening the bolts on the deck.
Remove the deck leveling blocks and verify
the height is correct and all four (4) chains are
tight.
Deck Lift Lever
1. Deck Height Adjustment Plates
2. Lift Lever
4
1150244-26 English