ASSEMBLY
PLACING THE GRASS COLLECTOR ONPREPARATION BEFORE THE FIRST
THE TRACTOR (FIG. 6)OPERATION
The tractor is shipped without gas, oil and electrolyte in
the battery, for safety reasons.
DANGER
!!
Lead acid batteries generate explosive gases. Keep
sparks, flame, and smoking materials away from
batteries. Always wear eye protection when around
batteries.
BATTERY PREPARATION
Battery provides maintenance free performance. Flush
Fig. 6
cover battery is completely leakproof and spillproof
Proceed to the following steps:when tipped to a 45 degree angle, so you do not have to
1. Lift the grass collector assembly with bothworry about electrolyte leakage when performing routine
hands. Slant it to an angle of approximately 40!maintenance.
(fig. 6).The battery is placed under the seat, and can be accessed
2. Slide the grass collector on the two supportby tilting the seat in the upright position (Fig. 8).
brackets located on the rear of the tractor.
3. When the grass collector is properly positioned,NOTE: The battery is shipped with electrolyte!
place the decal with the triangle symbol directly
opposite to the symbol on the rear of the tractor.
This will assist alignment in the future (Fig. 7).
Fig. 8
Fig. 7
WARNING
!!
This tractor is equipped with a safety micro-switch
and the cutting system will not function when the
grass collector assembly is not in place. Do not tamper
with this micro-switch.
English � 5 |