HUSQVARNA GRINDLUX4000 Instruction Manual

MAINTENANCE
Setting Up the Grinder
FIG. 83
WARNING!
Do not store petrol in the vicin-
!ity of the grinder. Sparks from
the grinding disc or the electri-
cal connection can ignite.
Place the grinder on a table and fold out the
support arms. The central support arm can be
anchored to the table at G to give a more stable
set-up.
Connect the cables to a 12-volt power source.
The power source can be a battery or a battery
charger.
The red cable is connected to + and the black to -.
If the cables are interchanged, the grinding disc
and feed motor will run in the wrong direction.
Sharpening with the Grinder
FIG. 84
The grinder can be used on bandsaw blades with
a pitch of 16 - 32 mm. The grinding disc may
need to be redressed for other tooth profiles.
WARNING!
The bandsaw blade is sharp
!and can cause cuts. Warning
for personal injury. Wear
protective gloves whenever
you handle the bandsaw blade!
1. Loosen the knob (43) and set the correct
cutting angle (F). See FIG. 83.
FIG. 85
2. Tighten the knob (43).
3. Check that the grinding disc has the correct
profile. See the templates at the rear of the
binder. The templates can be cut out and
placed against the grinding disc.
CAUTION! A new grinding disc must be
shaped before use. Use the supplied whet-
stone (52).
4. Fold up the grinding motor (45), hold up the
feed link (H), and insert the bandsaw blade.
The bandsaw blade should lie in the cut-outs
in the three support arms.
5. Check that the bandsaw blade rests on the
two supports (I). The support arms can be
bent if the bandsaw blade does not lie
against both the supports.
6. Adjust the bolt (J) so that the bandsaw blade
runs freely and at the same time is braced.
English � 9