EnglishGB
- the air circulated freely through the ventilation openings
- there is not a large build-up of frost on the inner walls
- the condenser (black grill) at the rear is clean (Fig. 12)
- the ambient temperature is excessively low (lower than
+15!C). In this case, set the thermostat control knob to a hi-
gher setting.
2) If the compressor functions continuously. Check that:
- the fast freeze switch is turned off
- the ambient temperature is too warm
- the door is not being opened too frequently.
3) The appliance is excessively noisy. Check that:
- the freezer is level
- the freezer is touching other furniture or walls, which can
cause vibration.
4) The appliance does not operate at all. The control li-
ghts are off. Check that:
- the thermostat control knob is not set to position O O
- there is not a power failure
- the plug is making good contact with the supply socket
- any automatic circuit breakers have tripped or any fuses blown
- the supply cable is intact (see also Note).
Note: When replacing a damaged supply cord, be sure the
new cord is correctly clamped. If you have followed the above
checks and your appliance still does not work properly, get in
touch with the Service Division.
Addresses and telephone numbers can be found on the
Service Registration Card.
State clearly what is wrong and the type and serial number of
your appliance. These data are on the rating plate (Fig. 5).
Door reversibility
1) Remove the lower hinge
2) Remove the door
3) Remove the screw
4) Change the pin
5) Change the foot
6) Remove the handle
7) Change the bush
A
8) Mount the handle
9) Fit the plugs
10) Change the handle
B
11) Fit the plugs
12) Mount the door
13) Mount the lower hinge.
Reversibility of the low temperature
compartment (Fig .A)
1) Open the door and remove the lower hinge. Remove the
door.
2) Remove the upper bush and mount it in the seat provided
at the left.
3) Remove the door stop and mount it at the right.
4) Mount the door (turn it by 180!).
5) Remount the lower hinge.
6-7) Plug the holes which remain unused with the clips (from
the accessory bag).
Reversibility of the low temperature
compartment (Fig .B)
1) Remove the left door block (2 screws).
2) Remove the hinges at the right hand side (4 screws) and re-
move the door.
3) Remount the hinges at the left hand side, remounting the door.
4) Remount the door block at the right hand side.
5) Plug the holes which remain unused with the 2 clips (from
the accessory bag).
8 |