AFTER-SALES SERVICE
Before contacting After Sales Service:
1. See if you can solve the problem yourself
with the help of the ?Troubleshooting Guide?.
2. Switch the appliance on again to see if the
problem has been solved.
If it has not, disconnect the appliance from
the power supply and wait for about an hour
before switching on again.
3. If the problem persists after this course of
action, contact After-sales Service.
Specify:
?the nature of the problem.
?the model.
?the Service number (the number after the Note:
word SERVICE on the rating plate on theThe direction of d oor opening can be
inside of the appliance).changed. If this operation is performed by
?your full address.After-sales Service it is not covered by the
?your telephone number and area code.warranty.
INSTALLATION
? Install the appliance away from heat soudamage torces. property resulting from failure
Installation in a hot environment, direct to observe these regulations.
exposure to the sun or installation nea? If r heatthe plug and socket are not of the same
sources (heaters, radiators, cookers) willtype, have the socket replaced by a qualified
increase power consumption and should electrician.
therefore be avoided.? Do not use extension leads or adaptors.
? Do not obstruct the circulation of air above
and below the appliance.
Disconnecting the appliance
? Clean the inside (see section ?Maintenance It must be possible to disconnect the appliance
and Cleaning?).by unplugging it or by means of a two-pole switch
? The following minimum distances must be fitted upline of the socket.
respected:
?30 cm from coal or paraffin stoves;
?3 cm from electric and/or gas stoves.
? To optimize appliance efficiency, leave a
5-cm gap above the appliance and make
sure that adjacent kitchen units are
sufficiently distanced to allow air circulation.
? Fit the spacers (if supplied) at the rear of the
appliance (see figure).
? Install the refrigerator in a dry, well-ventilated
place. Make sure it is level. Adjust the front
feet if necessary.
? Fit the accessories.
Electrical connection
? Electrical connections must be made in
accordance with local regulations.
? Voltage and power consumption are
indicated on the rating plate located inside
the appliance at the side of the crisper.
? Regulations require that the appliance is
earthed.
The Manufacturer declines all liabilities
for injury to persons or animals or
18 |
ACEC
