BEFORE USING THE DRYER / CONNECTIONS
1. Removing the packaging and checkStability:
?After unpacking, make sure that the dryer is When installing the dryer always carefully level the
undamaged. If in doubt, do not use the dryer. dryer adjusting the four feet and check the correct
Contact After-Sales Service or your local retailer.levelling with a spirit level.
?Keep the packaging materials (plastic bags, To built in the dryer
polystyrene parts, etc.) out of reach of children, as
they are potentially dangerous.Remove the work-top and replace it with the Built-
?Remove the protective foil from the control panel.In kit UBS 10 (according to Eec Electrical
Regulations), available at your dealer.
2. Electrical ConnectionsStacking kit
?Electrical connections must be carried out by a
qualified technician in compliance with the Your dryer can be stacked on top of your front
manufacturer's instructions and current standard loading washing machine. To do this, use stacking
safety regulations.kit AMH 542, available at your dealer.
?Electrical connection must comply with local Minimum housing dimensions:
Electricity Board regulations.Width:600 mm
?Voltage information, power consumption and the
Height:850 mm
required fuse protection is shown on the rating Depth:600 mm
plate mounted at the rear of the dryer.
?The manufacturer cannot accept any liability for
personal injury or damage to property resulting
from failure to adhere to these instructions.
?The dryer must be earthed as prescribed by law.
?Do not use extension leads or multiple adaptors.
?Before any maintenance on the dryer disconnect it
from the mains supply.
?Do not operate the dryer if it has been damaged
during transport. Contact one of our After-Sales
Service technicians.
?Mains cable replacement is only to be carried out by
After-Sales Service.
?After installation access to the mains plug has to be
guaranteed, or the all-pole disconnection has to be
possible with a switch.
3. Installation
?Do not install your dryer where it can be subject to
extreme conditions, such as: poor ventilation,
temperatures around freezing or above 35° C.
?Before running the first cycle ensure the water
container and heat exchanger are correctly
positioned.
?Only for water container top version: if possible use
the hose supplied to drain the water directly into
the domestic plumbing system. This will avoid
having to empty the water container at the end of
each drying cycle since the condensation water can
be directly drained away.
?Take care not to install the dryer on a deep-pile
carpet.
?Take care not to trap the mains cable between the
dryer and the wall.
11 |
ACEC
