50110087GB.fm Page 19 Thursday, March 2, 2006 4:37 PM
BEFORE USING THE WASHING MACHINE
1.Removing the packaging and checking5.Drain hose
?After unpacking, make sure that the washing Connect the drain hose to the ventilated siphon
machine is undamaged. If in doubt, do not use the or hook it over the edge of a sink by means of the
washing machine. Contact After-Sales Service or ?U? bend.
your local retailer
Check that the accessories and supplied parts are 6.Electrical connections
all presentElectrical connections must be carried out by a
Keep the packaging materials (plastic bags, qualified technician in compliance with the
polystyrene parts, etc.) out of the reach of manufacturer?s instructions and local safety
children; they can constitute a possible source of regulations
danger.Data concerning voltage, consumption and fuses
If the appliance was exposed to the cold prior to are located on the inside of the appliance door
delivery, keep it at room temperature for a few The appliance must be connected to the mains
hours before operating.exclusively by means of a socket with an earth
connection in accordance with established
2.Remove the transport boltsregulations.
The washing machine is fitted with a transport The washing machine must be earthed by law.
bolts to avoid any possible damage to the interior
The manufacturer declines all responsibility for
during transport. injury to persons or pets, or damage to property
Before using the washing machine, it is
caused by non-compliance with the above-
imperative that the transport bolts are removedmentioned regulations
3.Install the washing machineDo not use extension leads or multi sockets
Before any maintenance work on the washing
Remove the protective foil from the control
panelmachine disconnect it from the mains or turn off
the power supply
Move the appliance without lifting it by the
worktopAccess to the mains plug or to disconnection
from mains supply via a double-pole switch must
Install the appliance on a solid and level floor
surface. In the case of a yielding sub-floor the be ensured at all times following the installation
Do not operate the washing machine if it has
machine should be installed in a corner of the been damaged during transport. Inform the
room.
After-Sales Service
Make sure that all four feet are resting firmly on Mains cable replacement is only to be carried out
the floor and check that the appliance is perfectly
by After-Sales Service
level (use a spirit level)The washing machine must only be used in the
n case of wooden or so-called ?floating floors?
(for instance certain parquet or laminate floors), household for the prescribed uses
place the appliance on a 60 x 60 cm sheet of
plywood at least 3 cm in thickness which is Minimum housing dimensions:
Width: 600 mm
secured to the floor.
Height: 825 mm
4.Water inlet
Depth: 600 mm
Connect the water supply inlet hose in
accordance with regulations of your local water
company
Water inlet: Cold water only
Tap:3/4? threaded hose connection
Water Pressure
(flow pressure): 100-1000 kPa (1-10 bar).
19
Black process 45.0° 100.0 LPI |
ACEC
