00142GB.fm5 Page 14 Wednesday, September 20, 2000 10:10 AM
TROUBLESHOOTING GUIDE
The appliance will not switch on. Siphon clogged?
Power plug properly inserted in mains Remove the siphon and clean it under
socket?running water.
Mains fuse OK? Not enough water delivered? (See above
Power failure?paragraph ?No water or insufficient water
Tap turned on? Is water coming through?suppl?y).
Also se?e Detergent and Addi?ti avend s
Door closed??Care and Maintenan?.ce
Programme selected?
Appliance switched on?Machine vibrates during spin cycle.
No water or insufficient water supply. Machine perfectly horizontal with all four feet
on ground? (See?Installation ?).
Tap turned on completely? Transit screws and bar removed? The transit
Kink in water hose?
Water hose filter clogged? ?Care(See and screws and bar must be removed before the
machine is used (see ?Installati?).on
Maintenance?).
Water hose frozen up?Final spin results are poor.
Pump impeller obstructed? (See ?Removing
Waste water not pumped out.
the fi?lter/?Draining residual w?).ater
Drain hose installed correctly? (See
?Installation?).Washing results are poor.
Filter clogged? ?R(See emoving the fi?/lter Make sure to meet exactly the starting point
?Draining residual wa?). terof the programme, otherwise the first part of
Drain hose frozen up?the programme will not be executed (and this
Is the rinse hold button pressed?will reduce water filling, heating and
If yes, press the rinse hold button agaiwashin anng).d
the programme will continue with draining
Machine does not spin.
and spinning. Is the no spin button pressed?
Detergent and additive product residues in If yes, press the no spin button again and the
detergent drawer at end of wash. programme will continue with spinning.
Siphon installed correctly?
The siphon must be pushed down until the
stoppers are in touch.
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1. Try to remedy the problem
(see ?TroubleShooting Gui?).de
2. Restart the programme to see if the fault is
repeated.
3. If the malfunction persists, call After-Sales
Service and specify:
The nature of the problem.
The After-Sales Service sticker is on the inside
The exact model of the appliance.
The service code of the door.
(number after the word SERVICE).
Your full address.
Your telephone number and area code.
The After-Sales Service telephone number
and address can be found in the warranty or
on application to the retailer.
14 |
ACEC
