10. Replace the appliance in vertical position
and, if necessary, adjust the doors
(intermediate and lower hinge adjustment)
in order to ensure perfect adherence of
seals and correct coupling alignment.
11. Make sure that all the screws have been
tightened correctly and check the door seal
by placing a sheet of paper between the
cover and the seal: the sheet must resist
when it is pulled or moved.
Fig. 4
12. Switch on the appliance again.
Installation
After unpacking the appliance, check for damage. Any
damage must be immediately reported to the
supplier.
Keep the packaging materials (plastic
film, polystyrene parts, etc.) out of
reach of children and do not dispose
Fig. 5of in the environment.
7. Unscrew the lower pin of the refrigeratorChoose a well-ventilated place where the
door 8 (Fig.6), then fix it on the oppositeambient temperature is between + 16°C and +
side, after removing the protection. Put the32°C. Observe this warning in order to store
protection in the original position of the pinyour frozen food in good conditions and in
support. (Same procedure as for freezercompliance with European regulations.
door).Install your appliance away from sources of heat,
radiators, oven, cookers, direct and intense
sunlight ... Check the installation location to be
sure you have clearance on all sides.
Mount the two spacers 1 and 2 (fig. 7) on the
condenser grill to prevent it from touching the
wall.
Fig. 6
8. Position the refrigerator door fitting the
upper pin in its support, then fit the middle
hinge and screw it on.
9. Proceed as described above for the freezer
door and tighten the screws of the lower
hinge.
Fig. 7
16
63733036_gb.p651613/06/2002, 10:40 |
ACEC
